2.0L SUPERCHARGER HP PULLEY
ANY VEHICLE EQUIPPED WITH NEUSPEED’s 2.0L SUPERCHARGER KIT
PART # 58.45.06.028
INSTALLATION INSTRUCTIONS
PART LIST: 1 – 2.6” PULLEY 1 – 18mm NUT
TOOLS REQ: 1 – RATCHET 1 – PULLER SET
1 – 18mm SOCKET 1 – STRAP WRENCH
1. Release tension from belt and remove ribbed Vbelt from supercharger pulley.
2. Place strap wrench around pulley and remove M12
Nut (18mm Hex) securing pulley to supercharger
shaft.
©Copyright 2003, NEUSPEED
DOC.58.45.06.028 Rev. 02.17.03
®
. All rights reserved. Reproduction in whole or in part prohibited.
NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
Visit us on the web…http://www.neuspeed.com & http://www.apsoutlet.com
3. Slide pulley off of shaft. If you are unable to
remove the pulley by hand, use a puller set. Do not
use a hammer or pry bar to remove the pulley, since
this will damage the puller and/or shaft and void your
supercharger’s warranty.
4. Align keyway of new pulley with key on shaft and
slide pulley into position. Install belt and tension to
25 ft-lbs.
5. Apply loc-tite (262 or 272) to threads and install
nut. Torque nut to 45 ft-lbs.
Loading...