Netgear WC7600 Installation Guide
ProSAFE Wireless Controller WC7600
Package Contents
The package contains the following items:
• ProSAFE® Wireless Controller WC7600
• AC power cable
• Straight-through Category 5 Ethernet cable
• Rack-mount kit
• Rubber feet (4) with adhesive backing
• Installation guide
WARNING: DO NOT stack equipment, or place equipment in tight
spaces or in drawers. Be sure that your equipment is surrounded by at
least 2 inches (5 cm) of air space.
2
Meet Your Wireless Controller
Before you install your wireless controller, familiarize yourself with its
LEDs, buttons, and ports.
Front Panel
Digital access point counter
Slots and LEDs for optional
SFP GBIC modules
ID
Power
Status
Fan
Stack
Master
USB
Reset
USB port
LED Mode:
Green= Link at 10G, Blink Green=10G Active,
Yellow=Link at 1G, Blink Yellow=1G Active
LED Mode:
Left LED: Green=Link at 1G E,
Yellow=Link at 10/100M
Right LED:Green=Link,
Green Blink=Active
Ethernet port and LEDs
Reset button
LEDs (top to bottom):
Power, Status, Fan, Stack Master
Console 9600,N,8,1
COM port
3
Rear Panel
Power Status LED
Power input
4
Set Up the Wireless Controller
To set up the wireless controller:
1. Configure your computer with a static IP address of
192.168.0.210 and a subnet mask of 255.255.255.0.
2. Connect one end of the supplied Ethernet cable to the Ethernet
port on your computer and the other end to the Ethernet port on
the front panel of the wireless controller.
3. Connect the supplied power cord from the wireless controller to
an AC power outlet.
4. Verify that the following LEDs on the front panel are lit:
LED Description
Power The green Power LED is lit. If this LED is not lit, check the
connections and check to see if the power outlet is controlled
by a wall switch that is turned off.
Status The Status LED is lit yellow while the wireless controller is
initializing. After approximately two minutes, when the
wireless controller has completed its initialization, the Status
LED turns green.
5
Loading...