HEATED DISPLAY CASE
Model Series: 6421, 6422, 6423, & 6425
OPERATING INSTRUCTIONS
INTRODUCTION
1.Please read instructions before using this appliance.
2.When using electrical appliances, always follow basic precautions to reduce the risk of fire, electric shock and injury to persons.
3.Clean machine thoroughly before and after all uses using cleaning instructions below.
SAFETY INSTRUCTIONS
1.Plug electrical cord into a certified electrical outlet with a corresponding voltage rating as listed on the machine model labels.
2.Always unplug the electric cord when appliance is not in use and before cleaning, adjusting or maintaining this machine. Do not operate with a damaged cord or plug or after the machine malfunctions, has been dropped or damaged. Use authorized service for examination, electrical or mechanical adjustment or repair.
3.This machine will be HOT during use and for a short time after it is turned off – BE CAREFUL. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials away from appliance.
4.Use extreme caution when any appliance is used by or near children and whenever the appliance is left operating and unattended.
5.This appliance is not intended for use near or around water. Never locate appliance where it may fall into a water container.
6.Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electrical shock, fire or damage to the appliance. Do not block air intakes or exhaust in any manner. Do not use on soft surfaces where openings may become blocked.
PREPARATION
1.Remove all packing pieces and lift unit out of the box.
2.Remove any outside packaging.
3.Remove any plastic coating that may be affixed to stainless steel surfaces.
4.Be sure the round tier rack systems (equipped on models that rotate) are secure at the top and bottom.
5.CAUTION – To reduce the risk of fire, the appliance is to be installed in non-combustible surroundings only, with no combustible material within 18 inches of the sides, front, or rear of the appliance or within 40 inches above the appliance. The appliance is to be mounted on floors of noncombustible construction with non-combustible flooring and surface finish and with no combustible material against the underside, or on noncombustible slabs or arches that have no combustible material against the underside. Such construction shall in all cases extend not less than 12 inches beyond the equipment on all sides.
6.Unit can only be operated with the 4” legs provided. Failure to do so will cause damage to the unit.
7.Set unit on a flat surface.
8.Position unit near the power outlet. Avoid the use of extension cords. Do not run cord under carpeting or cover with runners or the like. Arrange cord where it will not be tripped over.
9.This appliance has hot and live electrical parts. Do not use in areas where gasoline, paint or flammable liquids are used or stored.
10.If unit fails to work properly when first operated call NEMCO customer service at 1-800-782-6761.
ELECTRICAL REQUIREMENTS
Refer to the product tag (serial plate) on the back of the unit for voltage and wattage requirements. Be sure to plug unit into grounded outlet with sufficient power.
WARNING: DURING NORMAL OPERATIONS THE EXTERIOR OF THE UNIT IS HOT.
OPERATION
1.Fill the water reservoir to provide humidity as required. Do not overfill.
2.Plug the unit into the appropriate power supply.
3.Turn heat switch to on position.
4.Turn temperature switch to high and preheat approximately 15 minutes.
5.Turn the temperature control to desired setting. (High, Medium or Low)
6.Load food products when pre-heat is complete.
7.Pull pin and lift the top coupling to remove rack.
8.To disconnect appliance, turn controls to off and remove plug from outlet.
Loading...