Mitsubishi SPACE RUNNER, SPACE WAGON WORKSHOP MANUAL

00109000812

.

.

WORKSHOP MANUAL

FOREWORD

This Workshop Manual contains procedures for
service mechanics, including removal, disassembly,
inspection, adjustment, reassembly and
installation. Use the following manuals in
combination with this manual as required.

TECHNICAL INFORMATION MANUAL

PYDE9802

WORKSHOP MANUAL

ENGINE GROUP PWEEjjjj

(Looseleaf edition)
ELECTRICAL WIRING PHDE9802
BODY REPAIR MANUAL PBDE9802
PARTS CATALOGUE

SPACE RUNNER B608V509Aj
SPACE WAGON B608W509Aj

General ........................

Engine .........................

Engine Lubrication .............

Fuel ...........................

Engine Cooling .................

Intake and Exhaust ............

Engine Electrical ...............

Engine and Emission Control ....

Clutch .........................

Manual Transmission ...........

Automatic Transmission ........

Propeller Shaft .................

Front Axle ......................

Rear Axle ......................

Wheel and Tyre .................

Power Plant Mount ..............

00
11
12
13
14
15
16
17
21
22
23
25
26
27
31
32

All information, illustrations and product
descriptions contained in this manual are current
as at the time of publication. We, however, reserve
the right to make changes at any time without prior
notice or obligation.

“GDI” is the trade mark which Mitsubishi Motors
Corporation holds.

Mitsubishi Motors Corporation Aug. 1998

E

Front Suspension ...............

Rear Suspension ...............

Service Brakes .................

Parking Brakes .................

Steering ........................

Body ...........................

Exterior ........................

Interior and Supplemental

Restraint System (SRS) ........

Chassis Electrical ..............

Heater, Air Conditioner and

Ventilation .....................

33
34
35
36
37
42
51
52
54
55

WARNING!
(1) Improper service or maintenance of any component of the SRS and seat belt with pre-tensioner,

or any SRS-related component, can lead to personal injury or death to service personnel (from
inadvertent firing of the air bag and seat belt with pre-tensioner) or to the driver and passenger
(from rendering the SRS inoperative).

(2) SRS components and seat belt with pre-tensioner should not be subjected to heat, so remove

the SRS-ECU, air bag module (driver’s side and front passenger’s side), clock spring, side
impact sensor, front seat assembly (side air bag module) and seat belt with pre-tensioner before
drying or baking the vehicle after painting.
SRS-ECU, air bag module, clock spring and side impact sensor: 93_C or more
Seat belt with pre-tensioner: 90_C or more

(3) Service or maintenance of any SRS component and seat belt with pre-tensioner or SRS-related

component must be performed only at an authorized MITSUBISHI dealer.

(4) MITSUBISHI dealer personnel must thoroughly review this manual, and especially its GROUP

52B - Supplemental Restraint System (SRS), before beginning any service or maintenance
of any component of the SRS and seat belt with pre-tensioner or any SRS-related component.

NOTE
Section titles with asterisks (*) in the table of contents in each group indicate operations requiring warnings.