T 6351
Operating Instructions
Tumble Dryers
T 6351
T 6551
T 6751
To prevent accidents
and machine damage read these
instructions before installation or
use.
ö]
M.-Nr. 05 640 910
2 M.-Nr. 05640910
Contents
WARNING AND SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Guide to the tumble dryer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
- Control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
- Pushbuttons / program selector . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
- Additional display with selector button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
- Program sequence and fault indicators / fault messages . . . . . . . . . . . . . . . . . . . . 10
- ”Reset” button / Emergency Stop button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Before using for the first time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
- Preparation of laundry . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
- Weight of loads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Program selection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
- Anti-crease . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
- Interrupting a program . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
- Emergency Stop button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Reprogramming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
- Changing the preset options of a drying program - examples . . . . . . . . . . . . . . . . . . 16
- Reprogramming possibilities / Programmable residual moisture . . . . . . . . . . . . . . . . . 19
Page
Cleaning and care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Guide to the data plate symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Leveling the unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Electrical connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Steam connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
M.-Nr. 05640910 3
WARNING AND SAFETY INSTRUCTIONS
Installation, repair and maintenance work
should be by a Miele authorized service
technician. Work by unqualified persons
could be dangerous and may void the warranty.
Read all instructions before installation or use
of the tumble dryer to prevent injury and machine damage.
The tumble dryer is only intended for dry-
ing fabrics washed in a water solution.
Check fabric care labels to verify materials
can be machine dried.
To prevent fires, do not use this tumble
dryer to dry the following:
– Articles containing foam rubber, rubber or
rubber like materials.
– Articles which have been treated with
flammable cleaning agents.
– Articles which have been splashed with
hair lacquer, hair spray, nail varnish remover, etc.
– Clothing which may be greasy,
fatty or impregnated with other residues.
Do not dry mops, floor cloths etc in this ma-
chine if they contain substances such as
wax or chemical cleaning agents.
Padded or filled fabrics (e.g. jackets or
cushions) should not be dried. Loose filling could cause a fire.
Some textiles get very hot during drying
and there may be a risk of high temperatures causing them to ignite in exceptional circumstances. They should therefore be taken
out of the machine as soon as the program
has finished and as soon as possible if there
has been a power failure. It is advisable to
keep a fire extinguisher near the machine at
all times.
Laundry must not be removed from the
dryer before the drying program has
finished, i.e., the cooling down phase must
be completed.
If hot laundry items are stacked or packed
they can be liable to auto-combustion.
Do not let children play in or near the ma-
chine. Do not let them play with the controls or operate the unit.
Make sure the drum is stationary be-
fore removing laundry. Never put you
hand into a drum that is still moving.
Installation, repair and maintenance work
should be by a Miele authorized service
technician. Work by unqualified persons
could be dangerous.
Be certain your appliance is properly in-
stalled and grounded by a qualified technician.
To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It
is imperative that this basic safety requirement
be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. The manufacturer cannot be
held responsible for damages caused by the
lack, or inadequacy of, an effective grounding
system.
Before installation or service, disconnect
the power supply to the work area by removing the fuse, ”tripping” the circuit breaker,
or unplugging the unit.
Do not damage, remove or bypass the
safety components, fixtures and control
elements of this machine.
Where there is any damage to the controls
or to the cable insulation the machine
must not be used until it has been repaired.
Faulty components must only be ex-
changed for Miele original spare parts.
Only when these parts are fitted can the
safety standards of the machine be guaranteed.
Do not touch the steam pipes and compo-
nents, there is a danger of burns.
When disposing of an old machine, pre-
vent hazards to children by removing the
drum door and the lint filter access panel.
Only use the dryer if all panels are
properly in place.
Fire and Explosion hazard
Never use or store gas or gasoline based
substances or any easily flammable substances near the machine.
Fire hazard
Do not use the machine without the built-in
lint filter in place. If the lint filter is damaged it
must be replaced immediately.
A build up of lint could block the airflow heating and ventilation, and impair the efficiency of
the machine.
4 M.-Nr. 05640910
WARNING AND SAFETY INSTRUCTIONS
Disinfecting and cleaning agents often con-
tain chlorides (salts) that can cause steel
surfaces to rust. To protect your machine from
rust damage, only use chloride free disinfecting and cleaning agents for laundry and disinfecting and for cleaning the machine. If you
are not sure about a particular agent contact
Miele’s Professional Division.
If you accidentally spill an agent containing
chloride on the machine it should be rinsed off
with water and dried with a soft cloth.
Do not use a high-pressure cleaner or
water jet to clean the machine.
Caution If the tumble dryer shuts off dur-
ing the drying cycle, without the fault indication light showing, a temperature limiter has
activated.
Check the seals and locks on the machine
door and the lint filter.
Check the condition of the air inlet and air outlet vents. If no damage is evident to any of
the parts checked, the dryer can be restarted.
If the fault occurs again, call the Miele Technical Service Department.
Accessories
Only use genuine Miele accessories. If
other parts are used, guarantee, performance
and product liability claims may become void.
Disposal of an old appliance
When discarding an old appliance, disconnect the power supply, remove the power cord
and any doors.
All personnel working with this machine must
be fully trained in all aspects of its use and
safety.
KEEP THESE OPERATING INSTRUCTIONS
IN A SAFE PLACE
M.-Nr. 05640910 5
Caring for the environment
Disposal of the packing material
The transport and protective packing
are environmentally friendly for
disposal and can be recycled.
Please recycle.
Disposal of an old machine
Old machines contain materials which can be
recycled. Please contact your local recycling
authority about the possibility of recycling
these materials.
6 M.-Nr. 05640910
Guide to the tumble dryer
1
85
2
3
4
7
1 -Main power switch 5 -Lint filter
2 -Control panel 6 -Lint compartment flap
3 -Drum door 7 -Four adjustable screw feet
4 -Door handle 8 -Vent pipe / Vent socket
Control panel
6
9 10 11 12 13
9 --Program sequence/Fault indicators
10--Program selector with selector button
11--Push buttons
12--Additional display
13--"Emergency Stop" button
M.-Nr. 05640910 7
Description of the machine
Push buttons
”On-Off s” button
”L Low temperature” button
Lowers the drying temperature for delicate fabrics (e.g. acrylics).
Press in the button to select this feature.
”l Buzzer” button
The end of a program can be indicated by a
buzzer.
Program selector
The program selector is used to select the program required.
COTTONS
A
Residual moisture value T6351 T6551/6751
Press in the button to select this feature.
”h ”Start" button
This button starts the program when pushed
in.
Extra dry (-4%) (-4%)
1
Normal + (-2%) (-2%)
2
Normal (3%) (3%)
3
Machine iron
4
Machine iron
5
Machine iron
6
MINIMUM IRON
B
Normal + (-2%) (-2%)
7
Normal (2%) (2%)
8
Machine iron
9
TIMED DRYING
C
without heating (15 min) (15 min)
0
with heating (20 min) (20 min)
!
End
r
- All the values given in brackets are preset standards.
And can be altered (see the following pages).
r
rr
rrr
r
(13%) (16%)
(20%) (22%)
(26%) (30%)
(8%) (8%)
8 M.-Nr. 05640910
Description of the machine
Additional display with selector button
Selector button
Display Indicator lights
Selector button "Residual moisture" /
"Time" / "Vented air"
"Residual moisture"
With this button the programmed residual
moisture values in programs 1 to 9 can be
changed.
Changes can only be made before the start of
the program. At the end of the cycle the program will revert to the preset standards.
"Time"
With this button the program duration can be
changed in program 0 (3 minutes to 1 hour)
and in program! (3 minutes to 3 hours).
recorded and displayed. The current residual
moisture value is shown during the program.
"Time"
Displays the time set for program 0 or ! .
The hours are shown in the left display field
and the minutes in the right fields. After the
program has started the remaining run time is
shown instead of the total time.
"Vented air"
Displays the current vented air temperature for
5 seconds while a program is running.
Indicator lights
"Residual moisture" / "Time"
"Residual moisture"
Lights up when the machine is turned on and
program 1 to 9 is chosen.
It goes out at the end of the program.
"Time"
Lights up when the machine is turned on and
a program between 0 and ! is chosen.
It goes out at the end of the program.
Changes can only be made before the start of
the program. At the end of the cycle the program will revert to the preset standards.
"Vented air"
If the button is pressed in while a program is
running and released immediately the current
vented air temperature will appear in the additional display for 5 seconds.
Display "Residual moisture" / "Time" /
"Vented air"
"Residual moisture"
Displays the residual moisture set for programs 1 to 9 .
A few minutes after the program has started
the residual moisture in the laundry is
M.-Nr. 05640910 9
Loading...