Marmitek IR 100 USB User guide

™

IR 100 USB

USER MANUAL 3

™

SAFETY WARNINGS

x To prevent short circuits, this product should only be used inside and only

in dry spaces. Do not expose the components to rain or moisture. Do not use the product close to a bath, swimming pool etc.

x Do not expose the components of your systems to extremely high

temperatures or bright light sources.

x In case of improper usage or if you have altered and repaired the product

yourself, all guarantees expire. Marmitek does not accept responsibility in the case of improper usage of the product or when the product is used for purposes other than specified. Marmitek does not accept responsibility for additional damage other than covered by the legal product responsibility.

x This product is not a toy. Keep out of reach of children. x Do not open the product: the device may contain live parts. The product

should only be repaired or serviced by a qualified expert.

x Only connect the adapter to the mains after checking whether the mains

voltage is the same as the values on the identification tags. Never connect an adapter or power cord when it is damaged. In that case, contact your supplier.

ENGLISCH

1. INTRODUCTION

Congratulation on buying the IR 100 USB™. With the IR 100 USB ™ you can extend the IR (infra-red) signals from your own remote control. The IR 100 USB™ gives you the opportunity to control your A/V equipment when it’s stored away in a closed cabinet or placed out of sight.

Marmitek products are manufactured with the utmost care and are exceptionally high quality. Please read this manual carefully and follow the instructions in order to get the best from this product.

2. SET CONTENT

1x IR 100 USB™ 1x User manual

IR 100 USB™ 3

3. HOW DOES IT WORK?

Place your A/V equipment in a closed cabinet or TV stand. Use one of the USB ports (1) on your A/V equipment (Digital TV decoder, Blu-ray player, audio installation) or TV to power the IR 100 USB. The IR receiver (2) must be installed within your remote’s line of sight and you should stick the IR blaster LED (3) inside the cabinet. Point the remote at the IR receiver to operate your equipment through the cabinet doors.

4. INSTALLATION

In order to check that the system works correctly, it is advisable to first test the set-up you had in mind. To do so, connect everything as described below but do not stick the components securely.

4.1 USB POWER

No power adapter is included with the IR 100 USB™. You can power the product by connecting it to a free USB port on your AV device or TV.

Please note the following: x Not all USB ports are active or provide enough power for proper

functioning.

x Some USB ports are disabled when turning off the set. In that case, you

can only use the IR 100 USB when the unit is on.

x Use a universal USB extension cable if you want to extend the cable. x If necessary, use a universal USB power adapter (5VDC, 500mA) if you

cannot use any USB port on your device.

4 © MARMITEK

+ 8 hidden pages