Logitech F0179A Users Manual

Setup Configuration Configuración

Logitech

Bluetooth

™

Cordless Headset

**See Page 24 for FCC  Info**

English

Safety

•Read these instructions.

•Keep these instructions.

•Heed all warnings.

•Follow all instructions.

•Caution: risk of electric shock. Do not open mains operated device.

•Do not use apparatus near water.

•Clean only with a dry cloth.

•Install in accordance with the manufacturer’s instructions.

• Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

•Do not defeat the safety purpose of the polarized plug. A polarized plug has two blades with one wider than the other. The wide blade is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

•Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

•Only use attachments/accessories specified by the manufacturer.

•Unplug this apparatus when unused for long periods of time or during lightening storms.

•Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

•Refer all servicing to qualified service personnel.

• The appliance shall be disconnected from the mains by pulling the mains power plug. The socket - outlet shall be installed near the equipment and shall be easily accessible.

WARNING:

TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT EXPOSE THIS APPA-

RATUS TO RAIN OR MOISTURE.

IMPORTANT SAFETY INFORMATION – FOR POWER SUPPLY ONLY

CAUTION

ELECTRIC SHOCK HAZARD

Introduction

English

Congratulations! Your new Logitech® Bluetooth

™

Cordless Headset will provide hours of hands-free

convenience wherever you use your Bluetooth™mobile phone.

Features

A. Noise canceling microphone B. LED indicator light C. Convenient volume control and

mute button D. Earclip adjuster E. Multi-function button. Use this

button to power on / off, and

answer / end calls (if supported

by your phone) F. Ear clip for comfortable,

secure fit G. Protective carrying case and

charger

The battery may not be fully charged when purchased. Please see “Charging your headset” on page 4.

Wearing and Using your Headset

English

Set-up - Pairing your Headset

English

Wearing your Headset

Press the earclip adjuster and slide the headset over either ear. Rotate the microphone boom so it is pointing toward the corner of your mouth. Adjust the headset until it feels comfortable.

Using your Headset

Turning the headset on and off:

Pushing the multi-function button and holding for 2 seconds will turn on the headset. To

turn the headset off, simply push the multi-function button and hold for 2 seconds. This

feature will work even if your phone does not support the multi-function call answer/end

feature.

Standby:

The headset will power down after 5 minutes of no activity. This will help conserve power.

Your headset will automatically power up when your phone receives a call.

Answering/ending a call:

To answer or end (hang-up) a phone call, simply push the multi-function button. When

pushing the button, do NOT hold the button; release it after pushing. Holding the button

for 2 seconds will turn off your headset. NOTE: Not all phones support the call answer/end

feature. If your phone does not support this feature, to answer a call first turn on your

headset by pushing and holding the multi-function button. Then, use your mobile phone to

answer/end the call.

Adjusting call volume:

To adjust the headset’s volume, simply push the “+” button to raise it, or the “ - ” to lower

it. A tone will sound indicating the change in volume. When the headset is turned OFF, the

current volume level is saved and stored.

Muting a call:

The headset can be muted by pushing both the “+” and “ - ” buttons at the same time. To

stop muting, push either the “+” or the “ - ” buttons. When your headset is muted, the LED

will flash at a faster rate than normal.

Pairing your Headset with your Bluetooth™Mobile Phone

You r Logitech®Bluetooth™Headset must be “paired” to a Bluetooth phone before it will function. The following section describes how to pair your Logitech Bluetooth headset to a typical Bluetooth phone.

1. Charge your Bluetooth™Cordless Headset using the charger/carrying case. Make sure the headset is fully charged before proceeding (see page 4 for instructions on charging your headset).

2. Press and hold down the Volume “–” and Multi-function buttons for approximately 7 seconds until the headset indicator light glows steadily orange. There will be some short flashes before it becomes steady.

3. While the light is still steadily lit, release the button. The indicator light will remain on for 60 seconds, indicating that the headset is in pairing mode and waiting to communicate with another Bluetooth device.

4. Follow the operating instructions for your Bluetooth phone to start the pairing process. Typically, this is done by going to a ‘setup’ or ‘connect’ menu and then selecting the options to ‘discover’ Bluetooth devices. It may take several seconds to establish a connection.

5. Your phone’s display should indicate to you that it found the ‘Logitech HS01’ headset and ask if you want to pair it. You should confirm this.

6. The phone’s display should then prompt you for a passkey or PIN. Enter a sequence of four ones: 1111.

7. To indicate that pairing has been successful, the headset indicator light will briefly flash rapidly before it goes back to flashing every 3 seconds in standby mode.

8. Your phone’s display may also ask whether you want to change the headset’s name. We recommend that you approve the ‘Logitech HS01’ name and not change it.

9. If the headset indicator light is still steadily lit and orange, pairing was unsuccessful and you will need to turn your headset off, return to step 1, and try again. You may want to restart your phone.

Frequently Asked Questions

English

Charging your Headset

English

Frequently Asked Questions

Can I use my headset on a plane?

No. At this time, the FAA prohibits the use of wireless/RF devices on airplanes.

How long should it take to charge my headset?

It should take approximately 4 hours to charge your headset when the battery is completely discharged. The LED light will turn green when charged.

What happens if the signal from the headset to the phone is lost?

A lost signal between the headset and phone could be caused either by a low battery or if the phone is out of the headset’s range. If this occurs, return the phone to within 30 feet of the headset. If the battery is low, re-charge the headset.

Should the headset be stored in the charger and charging while not in use?

It can be. No damage will occur by storing the unit in the case. The charge will stop when the headset is fully charged.

What if my phone doesn’t support the multi-function button?

Unfortunately, not all phones fully support the multi-function button on your headset. If this is the case, simply use your mobile phone to answer and end calls, just as you do when you’re not using the headset.

Where should I place the mini-boom?

For best results, place the end of the mini-boom as close to your mouth as possible.

Is there a car adapter available?

Yes . You can find it at www.logitech.com/adapter_offer.

Is there a power saving mode for my headset?

Yes. If the headset is not used for 5 minutes, the device will turn itself off to conserve power.

Charging your Headset

Your carrying case doubles as a charger for your Logitech Bluetooth

™

Cordless Headset. Charging your headset is simple:

1. Tu rn off the headset and place it into the charger, making sure all contacts are snug.

2. Plug the power adapter into the charger.

3. Connect the power adapter to a nearby electrical outlet.

4. The LED lights will be red when charging. If the LED is orange, the connection is not sufficient. Tighten the connection until the LED turns red, or green, if the headset is already fully charged.

5. When the LED turns green, your headset is fully charged which will take 4 hours.

Adjusting the mini-boom:

The mini-boom should be stored in its “closed” position with microphone element resting just above the multi-function button. To adjust, swivel the mini-boom gently and stop where the microphone element is as close to your mouth as possible.

IMPORTANT: DO NOT FORCE THE MINI-BOOM. IF YOU FEEL IT STOP, DO NOT FORCE IT. FORCING THE MINI-BOOM PAST THE HARD STOP IN EITHER DIRECTION WILL DAMAGE YOUR HEADSET.

Headset LED light:

The LED light will flash at different speeds and display different colors according to certain conditions.

Headset State LED Color LED Flash Speed

In-Use Green Slow In-Use, Mic Mute On Orange Fast Pairing Orange Solid Stand-by Green Extremely Slow Idle Green Slow Ringing Green Fast Low battery Red Depends on headset state Off No Light N/A

Recycling Information for Lithium-ion Batteries

Battery Removal

1. U s e fl at screw driver to open headset as shown.

2. Disconnect battery connector from circuit board.

3. Do not place in trash. Dispose of battery according to local battery recycling laws.

Battery Disposal & Recycling

English

Tec hnical Specifications – Battery Disposal & Recycling

English

End-of-life Battery Disposal Instructions

This device uses a 4.0V, 140mAh Lithium-ion battery that should last the lifetime of the device. If you suspect your battery may be dead, try charging it. If the battery does not recharge, please contact Logitech Customer Support for repair information.

The Logitech Bluetooth

™

Cordless Headset does not have a user-serviceable battery. Please do NOT attempt to change the battery yourself.

If the battery has died and you do not want Logitech to replace your battery, you should follow the disposal instructions below. Consult local laws and regulations for proper battery disposal in your region. If there are no local regulations concerning battery disposal, please dispose of the device in a waste bin for electronic devices.

Caution The battery used in this device may present a risk of fire or

chemical burn if mistreated. Do not disassemble, expose to heat above 100° C (212°F), or incinerate. Do not use or charge the batteries if they appear to be leaking, discolored, deformed, or in

any way abnormal. Do not leave your batteries discharged or unused for extended periods of time. When batteries are misused, they may explode or leak, causing burns and personal injury. If your batteries leak, use normal precaution and discard the batteries immediately. Leaking batteries can cause skin burns or other personal injury. Do not dispose of batteries in a fire or expose them to heat above 130° F (54°C). Do not immerse batteries in water. Keep batteries out of the reach of children.

Tec hnical Specifications

•Full duplex communication

•Rechargeable lithium-ion battery

•Charging case: 4.2 V.D.C.

•Range: up to 30 feet

•Telephone voice quality sound

Tec hnical Specifications

•Talk time: up to 7 hours

•Stand by time: up to 200 hours

•Bluetooth profile v1.1 compliant

•Weight: < 1 ounce

+ 11 hidden pages