Crayon Setup Guide
PRODUCT SETUP
To start using Logitech Crayon, simply turn on and draw. No software downloads or pairing required. Here are some tips
to get started:
1. Make sure you are using an iPad (6th generation). This is the only device that is compatible with Logitech Crayon.
2. Make sure iPad is updated to iOS 11.4 or above. To check your iOS version, go to iPad Settings → General → Software.
3. Disconnect any previously connected digital pencils, such as Apple Pencil
Settings → Bluetooth → Select the device you want to disconnect. If you do not want to forget other digital pencils,
simply turn your Bluetooth® o before using Crayon.
4. Press the power button for 1 second. If the LED turns green, you’re ready to go. If LED turns red, charge Crayon
before use.
SOFTWARE UPDATES
Updating the iOS on your iPad may aect your experience with Crayon. If you notice changes in functionality, simply
follow these steps:
1. Download Logitech Crayon software update at https://support.logitech.com/product/crayon-ipad/downloads
2. Connect Logitech Crayon to laptop via lightning cable.
3. Follow the prompts to update software.
To get notications about software updates, product tips, and more, visit https://support.logitech.com/product/
crayon-ipad/register
®
, prior to using Crayon by going to iPad
USE
Use with hundreds of Apple Pencil compatible apps, which are downloadable in the App Store. Logitech Crayon is not
pressure sensitive, so there is no need to press down hard on the iPad. Just tilt for thicker or thinner lines.
HOW TO CHARGE
1. Flip open the cap.
2. Insert lightning cable.
3. Connect cable to a power adapter or computer to charge.
It takes about 30 minutes to charge Crayon from 0 to 100%.
Note: Crayon will not work while charging.
English 1
LED behavior Logitech Crayon status
Fade in green Power on
Fade out green Power o
Solid green Fully charged
Breathing green Charging
Blinking red Battery level is critical (less than 5%)
Red when user presses button Battery level is low (less than 10%)
Green when user presses button Battery level is good
Yellow Firmware update
KNOW YOUR PRODUCT
Power buttonPencil tubeTip cover
LEDTip
Cap
Lightning port
REPLACEABLE PARTS
The tip can be damaged if Logitech Crayon is dropped and will also wear down with use. If either of these occur, the tip
will need to be replaced to avoid damaging the screen.
Replacement tip covers and caps can be purchased at https://support.logitech.com/product/crayon-ipad/spare-parts
Replacement tips can be purchased at https://www.logitech.com/product/crayon-replacement-tip
CARE AND STORAGE TIPS
• To preserve battery, power Crayon o when you are done using it. If you forget, Crayon will automatically shut o after
30 minutes of being idle.
• Though Crayon is designed with 4-foot drop protection, avoid drops as this might damage the tip of your Crayon or
the electronics inside.
• Do not leave the cap open as dirt, dust, and other foreign objects can get inside the charging port.
• If you need to clean Crayon, spray a cloth with water or a gentle cleaner (less than 15% alcohol) until it’s damp (not
soaked), and wipe the surface of the Crayon. Avoid getting moisture in the charging port, and make sure Crayon is
completely dry before storing.
© 2018 Logitech, Lo gi and the Logitech Logo are trademark s or registered trademarks of Logitech Europe S.A . and/or its ali ates in the U.S. and other countri es.
WEB-621-001162.002
English 2
Loading...