Lippert Components Ford Bumper Brace User Manual

HAPPIJAC
505 N. Kays Drive, Kaysville, Utah 84037
IN S T A L L A TI O N INS T R U C TIO N S
COMPANY
FORD BUMPER BRACE
For all steps below, refer to photos on reverse side of this page.
1. Locate the fender brace which runs from the bottom of the bed to the bottom of the fender, and remove the bolt at the bed end.
2. Place the bumper brace and bed brace, back over this hole and restart the bolt.
(Do not tighten.)
3. Align the other end of the bumper brace over the
existing hole in the bottom of the bumper and secure it with the hardware provided. (It may be
necessary to "tweek" the bumper back slightly to make this alignment.)
4. Re-tighten the bolt under the bed holding the fender brace and bumper brace.
5. Repeat steps 1 - 4 for opposite side.
insfmbb9110403
1999 & Newer Ford F250 Heavy / F350 Bumper Support
Underside of Bed
Bottom of Bumper
Underside of Bed
Added Bum
p
er Support
Added Bum
p
er Support
Existing Brace to Fender
Added bolt to existing Hole in Bumper
Added Bum
Existing bolt for fender brace
er Support
p
Existing Brace to Fender
Loading...