LINKSYS RE2000 User Manual

Linksys RE2000

Regulatory Information

Linksys RE2000

Table of Contents

Wireless Regulatory Information	1

FCC Statement	1
FCC Radiation Exposure Statement	1
Safety Notices	1
Safety Guidelines	1
Industry Canada Statement	2
Restrictions in the 5 GHz Band	2
Avis d’Industrie Canada	2
Restrictions dans la bande 5 GHz	2
Wireless Disclaimer	2
Avis de non-responsabilité concernant les appareils sans fil	2
Mexico	3
Declaration of Conformity with Regard to EU Directive 1999/5/EC (R&TTE Directive)	3
Wireless Equipment
(Wireless -AC Product)	4
National Restrictions	4
Product Usage Restrictions	4
Technical Documents on
www.myciscohome.com	4

WEEE Information	6

User Information for Consumer Products Covered by EU Directive 2002/96/EC on Waste
Electric and Electronic Equipment (WEEE)	6

Linksys RE2000

Wireless Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•• Reorient or relocate the receiving antenna

•• Increase the separation between the equipment or devices

•• Connect the equipment to an outlet other than the receiver’s

•• Consult a dealer or an experienced radio/TV technician for assistance

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

IEEE 802.11b or 802.11g operation of this product in the USA is firmware-limited to channels 1 through 11.

The device for the band 5150-5250 MHz is only for indoor usage to reduce the potential for harmful interference to co-channel mobile satellite systems.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Wireless Regulatory Information

Safety Notices

WARNING: Do not use this product near water, for example, in a wet basement or near a swimming pool.

WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

WARNING: This product contains lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.

Safety Guidelines

WARNING: Use the following safety guidelines to ensure your own personal safety and to help protect your product from potential damage. To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment, observe the following precautions.

•• Do not service this product except as explained in your system documentation.

•• If any of the following conditions occur, unplug the product from the electrical outlet and replace the part or contact your service provider/retailer:

•• The power cable or plug is damaged.

•• An object has fallen into the product.

•• The product has been exposed to water.

•• The product has been dropped or damaged.

•• The product does not operate correctly when you follow the operating instructions.

•• Keep your system away from radiators and heat sources.

•• Install product in a manner and location to ensure ventilation openings are not blocked.

•• Do not spill food or liquids on your system components, and never operate the product in a wet environment. If the system gets wet, contact your service provider/ retailer.

•• Do not push any objects into the openings of your system. Doing so can cause fire or electric shock by shorting out interior components.

•• Operate the product only from the type of external power source indicated on the electrical ratings label.

Linksys RE2000

•• Be sure that attached devices are electrically rated to operate with the power available in your location.

•• Position system cables and power cables carefully; route cables so that they cannot be stepped on or tripped over. Be sure that nothing rests on any cables.

•• Do not modify power cables or plugs.

•• Always follow your local and national wiring rules.

Industry Canada Statement

This Class B digital apparatus complies with Canadian ICES-003 and RSS210.

Operation is subject to the following two conditions:

1.This device may not cause interference and

2.This device must accept any interference, including interference that may cause undesired operation of the device.

Industry Canada Radiation Exposure

Statement

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Restrictions in the 5 GHz Band

The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to cochannel mobile satellite systems.

Because high power radars are allocated as primary users (meaning they have priority) in 5250-5350 MHz and 5650 5850 MHz, these radars could cause interference and/or damage to licensed exempt LAN devices.

Additional requirements for the band 5600-5650 MHz: Until further notice, devices subject to this Section shall not be capable of transmitting in the band 56005650 MHz, so that Environment Canada weather radars operating in this band are protected.

Avis d’Industrie Canada

Cet appareil numérique de la classe B est conforme aux normes NMB-003 et RSS210 du Canada.

L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes :

1.il ne doit pas produire de brouillage et

2.il doit accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.

Wireless Regulatory Information

Avis d’Industrie Canada concernant l’exposition aux radiofréquences

Ce matériel est conforme aux limites établies par IC en matière d’exposition aux radiofréquences dans un environnement non contrôlé. Ce matériel doit être installé et utilisé à une distance d’au moins 20 cm entre l’antenne et le corps de l’utilisateur.

L’émetteur ne doit pas être placé près d’une autre antenne ou d’un autre émetteur, ou fonctionner avec une autre antenne ou un autre émetteur.

Restrictions dans la bande 5 GHz

L’appareil pour la bande de 5150 à 5250 MHz est conçu pour usage à l’intérieur seulement afin de réduire le potentiel d’interférences pour les systèmes mobiles par satellite qui utilisent le même canal.

Du fait que les radars haute puissance ont la priorité dans les bandes 5250-5350 MHz et 5650-5850 MHz, ils pourraient causer des interférences ou endommager les périphériques réseau sans fil.

Autres restrictions pour la bande 5 600-5 650 MHz : sauf avis contraire, les périphériques concernés par cette section ne doivent pas être capables de transmettre dans la bande 5 600-5 650 MHz afin de protéger les radars d’Environnement Canada qui l’utilisent.

Wireless Disclaimer

The maximum performance for wireless is derived from IEEE Standard 802.11 specifications. Actual performance can vary, including lower wireless network capacity, data throughput rate, range and coverage. Performance depends on many factors, conditions and variables, including distance from the access point, volume of network traffic, building materials and construction, operating system used, mix of wireless products used, interference and other adverse conditions.

Avis de non-responsabilité concernant les appareils sans fil

Les performances maximales pour les réseaux sans fil sont tirées des spécifications de la norme IEEE 802.11. Les performances réelles peuvent varier, notamment en fonction de la capacité du réseau sans fil, du débit de la transmission de données, de la portée et de la couverture. Les performances dépendent de facteurs, conditions et variables multiples, en particulier de la distance par rapport au point d’accès, du volume du trafic réseau, des matériaux utilisés dans le bâtiment et du type de construction, du système d’exploitation et de la combinaison de produits sans fil utilisés, des interférences et de toute autre condition défavorable.

+ 8 hidden pages