Door Locks ............................................................................................................................................ 98
Floor mat installation..............................................................................................................................11
Front Seats ............................................................................................................................................... 19
Fuel Tank Cap ......................................................................................................................................102
Garage Door Opener........................................................................................................................91
Hands-free System For Cellular Phone (with Lexus Display Audio)
If the “History” or “Past Record” screen is not displayed, select “History” or “Past Record”.
Vehicles with a navigation system
Average fuel consumption
1
Previous fuel consumption record
2
Best recorded fuel consumption
3
Update the average fuel consumption
4
data
Reset the past record data
“Trip Information” screen appears
6
“Energy Monitor” screen appears (if
Vehicles with Lexus Display Audio system
7
equipped)
13
ES350_QG_OM33A70U_(U)
Keys
InformationProvidedby:
■ Electronic key
■ Mechanical key
Smart access system with push-button start
(P.1 5, 24)
Wireless remote control (P.1 5 )
To take out the mechanical key, push the
release button and take the key out.
After using the mechanical key, store it in
the electronic key. Carry the mechanical
key together with the electronic key. If
the electronic key battery is depleted or
the entry function does not operate
properly, you will need the mechanical
key.
14
ES350_QG_OM33A70U_(U)
■ Wireless remote control
The following operations can be performed simply by carrying the electronic key on your
person, for example in your pocket. (The driver should always carry the electronic key.)
For details on starting the engine, see page 24.
InformationProvidedby:
Smart Access System with Push-button Start
Locks all the doors
1
Unlocks all the doors
2
Pressing the button unlocks the driver’s
door. Pressing the button again within
5 seconds unlocks the other doors.
Opens the windows and moon roof
3
(press and hold)
Opens the trunk (press and hold)
4
If the vehicle is equipped with a power
trunk opener and closer, the trunk lid
automatically opens fully.
Sounds the alarm (press and hold)
5
*
*: This setting must be customized at your
Lexus dealer.
■ Entering the vehicle
15
Grip the driver’s door handle to unlock the
door. Grip the passenger’s door handle to
unlock all the doors.
Make sure to touch the sensor on the
back of the handle.
The doors cannot be unlocked for 3 seconds after the doors are locked.
ES350_QG_OM33A70U_(U)
■ Exiting the vehicle
InformationProvidedby:
■ Opening the trunk
Touch the lock sensor (the indentation on
the upper part of the door handle) to lock
all the doors.
Press the button.
If the vehicle is equipped with power
trunk opener and closer, the trunk lid
automatically opens fully.
16
ES350_QG_OM33A70U_(U)
■ Changing the door unlock function setting
InformationProvidedby:
It is possible to set which doors the entry function unlocks using the wireless remote control.
1
Turn the “START STOP ENGINE” switch off.
2
When the indicator light on the key surface is not on, press and hold ,
or for approximately 5 seconds while pressing and holding .
The setting changes each time an operation is performed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds, and
repeat step .)
2
Multi-information
display
Unlocking functionBeep
Holding the driver’s door handle unlocks only the driver’s
door.
Holding a passenger’s door
Exterior: Beeps 3 times
Interior: Pings once
handle unlocks all the doors.
Holding a door handle unlocks
all the doors.
Exterior: Beeps twice
Interior: Pings once
To prevent unintended triggering of the alarm, unlock the doors using the wireless
remote control and open and close a door once after the settings have been changed. (If
a door is not opened within 60 seconds after is pressed, the doors will be locked
again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P.1 8 )
For details on what to do when the electronic key does not operate properly, see page 108.
17
ES350_QG_OM33A70U_(U)
Theft Deterrent System
InformationProvidedby:
■ Engine immobilizer system
The indicator light flashes after the “START
STOP ENGINE” switch has been turned off
to indicate that the system is operating.
The indicator light stops flashing after the
“START STOP ENGINE” switch has been
turned to ACCESSORY or IGNITION
ON mode to indicate that the system has
been canceled.
■ Alarm
The alarm uses light and sound to give an alert when an intrusion is detected.
To set the alarm:
Close the doors, trunk and hood, and lock all the doors. The system will be set automatically
after 30 seconds.
The indicator light changes from being on to flashing when the system is set.
To deactivate or stop the alarm:
● Unlock the doors or open the trunk.
● Turn the “START STOP ENGINE” switch to ACCESSORY or IGNITION ON mode, or
start the engine. (The alarm will be deactivated or stopped after a few seconds.)
18
ES350_QG_OM33A70U_(U)
Front Seats
3
6
InformationProvidedby:
■ Adjustment procedure
Seat position adjustment switch
1
Seatback angle adjustment switch
2
Seat cushion (front) angle adjustment
switch
Vertical height adjustment switch
4
Lumbar support adjustment switch
5
Seat cushion length adjustment switch
(if equipped for driver’s side)
19
ES350_QG_OM33A70U_(U)
Head Restraints
Lock release button
Lock release button
Lock release button
InformationProvidedby:
■ Front seats
■ Rear seats
Vertical adjustment
Up
1
Pull the head restraints up.
Down
2
Push the head restraint down while
pressing the lock release button.
Horizontal adjustment
The position of the head restraint can be
adjusted forward in 4 stages.
If the head restraint is pulled forward
from the foremost position, it will return
to the rearmost position.
OutboardCenter
Up
1
Pull the head restraints up.
Down
2
Push the head restraint down while pressing the lock release button.
20
ES350_QG_OM33A70U_(U)
Driving Position Memory (if equipped)
This feature automatically adjusts the front seats, steering wheel (power adjustment type)
and outside rear view mirrors to suit your preferences.
2
3
InformationProvidedby:
■ Driving position memory
Recording procedure
■
1
Check that the shift lever is in P.
Turn the “START STOP ENGINE” switch to IGNITION ON mode.
3
Adjust the driver’s seat, steering wheel, and outside rear view mirrors to the desired
positions.
4
■ Rec all procedure
1
Check that the shift lever is in P.
2
Turn the “START STOP ENGINE” switch to IGNITION ON mode.
While pressing the “SET” button, or within 3
seconds after the “SET” button is pressed,
press button “1”, “2” or “3” until the buzzer
sounds.
If the selected button has already been
preset, the previously recorded position
will be overwritten.
Press one of the buttons for the driving
position you want to recall until the buzzer
sounds.
21
ES350_QG_OM33A70U_(U)
■ Memory recall function (driver’s side only)
InformationProvidedby:
Each electronic key can be registered to recall your preferred driving position.
■ Registering procedure
1
Check that the shift lever is in P.
2
Turn the “START STOP ENGINE” switch to IGNITION ON mode.
3
Recall the driving position that you want to record.
4
While pressing the recalled button, press
and hold the door lock switch (either lock
or unlock) until the buzzer sounds.
If the button could not be registered, the
buzzer sounds continuously for approximately 3 seconds.
22
ES350_QG_OM33A70U_(U)
Outside Rear View Mirrors
InformationProvidedby:
Selects a mirror to adjust (“L”: left or
1
“R”: right)
Adjust the mirror up, down, in or out
2
using the switch
■ Folding the mirrors
Push the mirror back in the direction of the
vehicle’s rear.
■ When either “L” or “R” of the mirror select switch is selected, the outside rear view mir-
rors will automatically angle downwards when the vehicle is reversing in order to give a
better view of the ground. To disable this function, select neither “L” nor “R”.
■ If the mirror angle adjustment switch is operated while the linked mirror function is in
operation, the angle and position of the mirrors can be remembered, and the mirrors will
operate at the angle adjusted to the last time the linked mirror function was operated.
However, because the mirrors move based on the angle they are in when the linked mirror function is not operating, the mirror angle when the linked mirror function is operating will also be changed if the mirrors are adjusted while the function is not operating.
23
ES350_QG_OM33A70U_(U)
Engine (Ignition) Switch
Performing the following operations when carrying the electronic key on your person
starts the engine or changes “STAR T STOP ENGINE” switch modes.
4
InformationProvidedby:
■ Starting the engine
1
Check that the parking brake is set.
2
Check that the shift lever is set in P.
3
Firmly depress the brake pedal.
will be displayed on the
multi-information display. If it is not
displayed, the engine cannot be
started.
Press the “START STOP ENGINE”
switch.
The engine will crank until it starts or
for up to 30 seconds, whichever is
less.
Continue depressing the brake pedal
until the engine is completely started.
The engine can be started from any
“START STOP ENGINE” switch
mode.
ES350_QG_OM33A70U_(U)
24
■ Stopping the engine
2
InformationProvidedby:
1
Stop the vehicle.
Shift the shift lever to P.
3
Set the parking brake.
4
Press the “START STOP ENGINE” switch.
5
Release the brake pedal and check that “POWER ON” on the multi-information display is off.
■ Changing “START STOP ENGINE” switch modes
Modes can be changed by pressing the “START STOP ENGINE” switch with the brake
pedal released. (The mode changes each time the switch is pressed.)
Off
*
The emergency flashers can be used.
The multi-information display will not be
displayed.
ACCESSORY mode
Some electrical components such as the
audio system can be used.
“POWER ON” will be displayed on the
multi-information display.
IGNITION ON mode
All electrical components can be used.
“POWER ON” will be displayed on the
multi-information display.
*: If the shift lever is in a position other than
P when turning off the engine, the
“START STOP ENGINE” switch will be
turned to ACCESSORY mode, not to
off.
25
ES350_QG_OM33A70U_(U)
■ If your vehicle has to be stopped in an emergency
3
Press and hold for 2 seconds or more
or press briefly 3 times or more
InformationProvidedby:
Only in an emergency, such as if it becomes impossible to stop the vehicle in the normal way,
stop the vehicle using the following procedure:
1
Steadily step on the brake pedal with both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort required to slow
the vehicle.
2
Shift the shift lever to N.
If the shift lever is shifted to N
3
After slowing down, stop the vehicle in a safe place by the road.
4
Stop the engine.
If the shift lever cannot be shifted to N
Keep depressing the brake pedal with both feet to reduce vehicle speed as much as
possible.
4
To stop the engine, press and hold the
“START STOP ENGINE” switch for 2 consecutive seconds or more, or press it briefly
3 times or more in succession.
5
Stop the vehicle in a safe place by the road.
26
ES350_QG_OM33A70U_(U)
Automatic Transmission
InformationProvidedby:
■ Shifting the shift lever
While the “START STOP ENGINE” switch is in IGNITION ON mode, move the shift
lever with the brake pedal depressed.
When shifting the shift lever between P and D, make sure that the vehicle is com-
pletely stopped.
■ Shift position purpose
Shift positionObjective or function
PParking the vehicle/starting the engine
RReversing
NNeutral
D
S
1
*
: Shifting the shift lever to D allows the system to select a gear suitable for the driving con-
Normal driving*
S mode driving*
1
2
ditions.
Setting the shift lever to D is recommended for normal driving.
2
*
: Selecting shift ranges using S mode restricts the upper limit of the possible gear ranges,
controls engine braking force, and prevents unnecessary upshifting.
27
ES350_QG_OM33A70U_(U)
■ Selecting gears in the S position
InformationProvidedby:
When the shift lever is in S, the shift lever can be operated as follows:
Upshifting
1
Downshifting
2
The selected shift range, from S1 to S6,
will be displayed in the meter.
The initial shift range in S mode is set
automatically to S5 or S4 according to
vehicle speed. However, the initial shift
range may be set to S3 if AI-SHIFT has
operated while the shift lever was in D.
■ Shift ranges and their functions
Automatically selecting gears between 1 and 6 according to vehicle speed and driving
conditions. However, the gear is limited according to selected shift range.
You can choose from 6 levels of engine braking force.
A lower shift range will provide greater engine braking force than a higher shift range,
and the engine speed will also increase.
28
ES350_QG_OM33A70U_(U)
Tur n Si g nal Leve r
InformationProvidedby:
Right turn
1
Lane change to the right (move the
2
lever partway and release it)
The right hand signals will flash 3 times.
Lane change to the left (move the lever
3
partway and release it)
The left hand signals will flash 3 times.
Left turn
4
■ Customization
The number of times the turn signals flash during a lane change can be changed.
29
ES350_QG_OM33A70U_(U)
Multi-information Display
The multi-information display presents the driver with a variety of driving-related data
including the current outside air temperature.
InformationProvidedby:
■ Display contents
● Trip information
• Eco Driving Indicator Zone Display
• Outside temperature
• Current fuel consumption
• Average fuel consumption after refueling
• Average fuel consumption
• Average vehicle speed
• Driving range
•Elapsed time
• Tire inflation pressure (P.4 9 )
● Drive monitor
• Outside temperature
• Average fuel consumption after refueling
• Driving range
● Intuitive parking assist display
equipped)
● Dynamic radar cruise control display
equipped)
● LDA (Lane Departure Alert) display
equipped)
● Warn in g m es sa ge s
* (if
* (if
* (if
*: Automatically displayed when the sys-
tem is used. Display can be switched by
pressing the “DISP” button.
ES350_QG_OM33A70U_(U)
30
Loading...
+ 80 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.