Legrand PCIQ PDU-TS1 User Manual

Wiremold / Legrand electrical systems conform to and should be properly grounded in compliance with requirements of the current National Electrical Code or codes administered by local authorities.

All electrical products may present a possible shock or fire hazard if improperly installed or used. Wiremold / Legrand electrical products may bear the mark as UL Listed and/or Classified and should be installed in conformance with current local and/or the National Electrical Code.

PDU-TS1 Temperature Sensor

INSTALLATION INSTRUCTIONS

Installation Instruction No.: 1 007 726 – April 2008

IMPORTANT: Please read all instructions

before beginning.

Connecting the Sensor:

The only operation needed to install and operate the temperature sensor is to connect its jack into the “sensor port” on to the Wiremold smart PDU product. We suggest locating the probe to the hottest known location within the cabinet.

Wiremold / Legrand

U.S. and International: 60 Woodlawn Street • West Hartford, CT 06110 1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251 Canada: 570 Applewood Crescent • Vaughan, Ontario L4K 4B4 1-800-723-5175 • FAX 905-738-9721

1 007 726 0408

Temperature probe connection to Power Commander IQ series.

Products Covered: SPDU20-0U, SPDU8-1U, SPDU16-2U

NOTE: Using the sensor with any other than mentioned products might damage sensor and/or equipment to which it

is connected.