LEGRAND Pass -Seymour PSWO LightSense Installation Instructions Manual

PSWO

LightSense™Wireless Repeater

Specifications

PSWO Input Voltage . . . . . . . . . . . . .9-12VDC, 50mA minimum

AC-DC adapter (provided)

Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .120VAC, 60Hz

Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9VDC, 50mA

Installation Instructions

Patents pending

Syracuse, NY 13221-4822

www.passandseymour.com

800.223.4185

UNIT DESCRIPTION

Use the LightSense™ PSWO Wireless Repeater in
large installations, where the standard range
(approximately 25m/80’) is insufficient, or in buildings
with difficult wireless reception conditions.

The wireless repeater effectively doubles the
transmit/receive range of LightSense wireless
devices.

In large applications or where radio reception is difficult, you may use two
repeaters, strategically located. For extremely large or difficult applications
requiring more than two repeaters, please contact Technical Support for
assistance.

The wireless repeater also offers a security feature – real life occupancy
emulation. It continuously records a one-week loop of actual LightSense
wireless network traffic, and can play it back when you’re away from home – it
will look like the house is occupied.

While we recommend the repeater for either or both of these functions, you
should use only the number required for effective wireless communication
throughout the home. Using too many repeaters will not provide any additional
benefit and may slow down network communication. For in-depth system
design guidance, see Application Assistance, below.

LightSense Wireless

LightSense wireless devices use radio signals to communicate with each other
to control lighting and other types of electric loads in selected areas.
LightSense wireless devices use the 900MHz band for high-speed control
communication. Using the patented “frequency-agile” Top Dog™ technology,
LightSense wireless devices avoid interference with other 900MHz devices,
such as cordless phones and baby monitors.

Application Assistance

The

LightSense Installation Guide

the LightSense wireless control system, including setting up scenes and
presets. Instructions for installation and use are included with the relevant
LightSense wireless devices. Application support information, the

Guide

and the

Seymour/Legrand website, www.passandseymour.com.

LightSense Installation Guide

provides more information about configuring

are available at the Pass &

Repeater
Identification Icon

Specification

Call 800.223.4185 for Technical Support

INSTALLATION

PSWO Repeater

Power Supply

Status LED

1. Locate the repeater in a central location, taking into consideration both the
horizontal and vertical space in the home. In a 2-story plus basement home,
a good position may be on the first floor atop a kitchen cabinet.

Do not locate the PSWO Wireless Repeater close to any

device that may cause interference or behind large metal

objects that can block radio reception. Avoid fluorescent light

fixtures, TV sets, computers, refrigerators, microwave

2. Plug the external power supply into a convenient 120 volt outlet, and
connect the power cord to the repeater’s power socket.

3. The status LED will light yellow, indicating that the unit is ready for
configuration.

ovens, range hoods, safes, etc.

Visit our website for FAQs: www.passandseymour.com