La Crosse Technology WS-7044UD, WS-7044UG, WS-7044UA User Manual

WS-7044U

Wireless 433 MHz

Miniature Wood Weather Station

Instruction Manual

TABLE OF CONTENTS

Topic Page

Inventory of Contents/Additional

3 Equipment Quick set-up guide 3 Battery installation 4-6 Time 7-8 Features: 9-15

Indoor temperature 10 Weather Forecast icons & tendency

10-13 arrows

Outdoor temperature with

13-15 Minimum & Maximum Mounting 15-19 Troubleshooting 19 Maintenance and Care instructions 20 Specifications 21-22

INVENTORY OF CONTENTS

1. WS-7044U—Weather Station.

2. TX2U—Remote Temperature Transmitter.

3. Three each, ½” Philips screws.

4. One strip double-sided adhesive tape.

5. Instruction manual & Warranty card.

ADDITIONAL EQUIPMENT

1. Four fresh AAA 1.5V batteries.

2. One Philips screwdriver.

QUICK SET-UP GUIDE

1. Insert two AAA batteries into each unit.

2. Wait 10 minutes to ensure transmission reception.

3. Set the time.

4. Mount units in desired locations.

DETAILED SET-UP GUIDE

I. BATTERY INSTALLATION

A. REMOTE TEMPERATURE

TRANSMITTER

1. Remove the battery cover. Place your thumb over the two air-vent slots on the face of the Remote Temperature Transmitter, push down gently, slide battery cover down and off.

2. Observing the correct polarity, install 2 AAA batteries. The batteries will fit tightly (to avoid start-up problems make sure that they do not spring free during installation).

3. Replace the battery cover.

attery

Cover

B. WEATHER TEMPERATURE

STATION

1. Remove the battery cover. Pull up and out from the slot located in the central position of the battery cover.

2. Observing the correct polarity, install 2 AAA batteries. The batteries will fit tightly (to avoid start-up problems make sure that they do not spring free during installation).

3. Replace the battery cover.

Note:

After the batteries have been installed into the Weather Temperature Station the LCD segments should light up. Also within 3 minutes, the Outdoor Temperature should be displayed in the OUTDOOR LCD. If any of this does not occur, remove all batteries

attery

Cover

and install them again—carefully observing the polarity.

C. LOW-BATTERY & BATTERY

REPLACEMENT FEATURES

When the batteries become weak in the Weather Temperature Station, a low battery indicator (shaped as a battery) appears in the LCD screen between the Hour display and the Minute display. When you replace the batteries in the Weather Temperature Station, the LCD screen will continue to display its stored information for 20 seconds. This means that if you can install the new batteries within this 20-second time period you do not need to program the Station again.

II. TIME

A. THE TIME DISPLAY

The time is displayed vertically (with the hour displayed above the minutes) rather than in the conventional horizontal format. The hour and minute displays are separated by a flashing dot, which indicates the seconds. The time is only displayed in the 12h mode, there is no 24h option.

B. SETTING THE TIME

Note:

The “SET” and the “+” buttons are located on the backside of the Weather Temperature Station, and are labeled accordingly. If no buttons are pressed within 10 seconds of pressing the “SET” button, the Weather Temperature Station will return to its normal time display.

1. Press the SET button. The hour digit in

the HOUR LCD will flash. Press the + button (repeatedly) until you reach your desired hour.

2. Press the SET button a second time.

The minute digit in the MINUTE LCD will flash. Press the + button (repeatedly) until you reach your desired minute.

3. Press the SET button again to confirm

settings, and to return to the normal time display.

+ 16 hidden pages