La Crosse Technology WS-7034U User Manual

WS-7034U

Wireless 433 MHz

Temperature Station

Instruction Manual

TABLE OF CONTENTS

Topic Page

Quick Setup 3-5
Inventory of Contents 6-7
Detailed Setup Guide

Battery Installation 8
Setting the Time 9-10
Selecting Units of
Measurement

Features

Minimum and Maximum
Temperatures

Resetting Minimum and

Maximum Temperatures
Adding additional remote
temperature sensors
(optional)
Mounting 15-16
Troubleshooting 17-18
Maintenance and Care 19
Specifications 20-21
Warranty Information 22-25

10

11

12

13-14

2

QUICK SETUP

Hint: Use good quality Alkaline
Batteries and avoid rechargeable
batteries.

1. Have the indoor temperature station

and remote temperature sensor 3 to
5 feet apart.

2. Batteries should be out of both

units for 10 minutes.

3. Place the batteries into the remote

temperature sensor first then into

the indoor temperature station.
(All remote temperature sensors must be
started before the indoor temperature
station)

4. DO NOT PRESS ANY BUTTONS

FOR 10 MINUTES.

In this time the indoor temperature
station and remote temperature sensor
will start to talk to each other and the

3

display will show both the indoor
temperature and an outdoor temperature.
If the indoor temperature station does
not display both temperatures after the
10 minutes please retry the set up as
stated above. After both indoor and
outdoor temperatures are displayed for
10 minutes you can place your remote
temperature sensor outdoors and set
your time.

The remote temperature sensor should
be placed in a dry, shaded area. The
remote temperature sensor has a range
of 80 feet. Any walls that the signal
will have to pass through will reduce
distance. An outdoor wall or window
will have 20 to 30 feet of resistance and
an interior wall will have 10 to 20 feet
of resistance. Your distance plus
resistance should not exceed 80 ft. in a
straight line.

4

NOTE: Fog and mist will not harm
your remote temperature sensor but
direct rain must be avoided.

To complete the set up of your indoor
temperature station after the 10 minutes
have passed please follow the steps on
pages 8-9.

INVENTORY OF CONTENTS

1.

2.

3.

4.

The indoor temperature station (Figure

1)

The remote temperature sensor (TX6U)

and mounting bracket. (Figure 2)

3 each, 1/2” Philips screws.

One strip of double sided adhesive tape.

5.

Figure 1

Instruction Manual and
Warranty Card.

Holder

Figure 2

5

ADDITIONAL EQUIPMENT

(not included)

1.

1 Philips screwdriver.

2.

2 Fresh AAA Alkaline batteries.

3.

2 Fresh AA Alkaline batteries

DETAILED SETUP GUIDE

Battery Installation

1. Install 2 AA

batteries in the

remote temperature

sensor. Make sure

they do not spring

free, or start-up

problems may occur.

2.

Install 2 AAA
batteries in the
indoor temperature
station. Do not

press any buttons
for at least ten
minutes.

Battery
Cover

6