La Crosse Technology LTV WL1 User Manual
LTV-WL1 Specifications 10-10-17
Features:
• TX button for transmission
• Receive push notifications when water is detected to your La Crosse View app
• Power: 2 AA batteries
• Transmission Range 400 feet (121.92 meters)
• Water detection when water is 1/32" deep
Position Water Leak Sensor
Sensor works best simply placed on a floor. IF place vertically the deep of the water to trigger the sensor needs to be
higher.
Mounting
Hole
Water
detectors
Insert Batteries
• Water leak sensor requires 2-AA batteries.
• Twist front of sensor to the left to unlock battery cover.
• Insert two AA batteries according to polarity.
• Place battery cover on front of sensor and twist right until marks line up to insure water resistance.
Alignment
marks
1
LTV-WL1 Specifications 10-10-17
LED Light
• Press the TX button at any time to force transmission the LED will flash.
• When water is detected, the LED will flash once per second, for 30 seconds.
• When water is no longer detected, the water leak detector will stop flashing.
• When the battery on the water leak detector needs to be replaced, the LED will flash once every second for 5 seconds,
every 30 seconds.
App Notifications
• Press the TX button at any time to force transmission the app should receive the data instantly
• When water is detected, a push notification will be sent to your mobile device from the La Cross View app.
• When water is no longer detected, a push notification will let you know the alert is no longer active.
• If connection is lost a push notification will be sent to your mobile device to alert you to check connection.
• When the battery is low and needs to be replaced, a push notification will notify you of the low battery.
Transmission and Delta
• Sensor will check the delta at the intervals below and if Delta is not met it will not transmit data until the transmit
interval is met.
• If Delta is met, sensor will transmit immediately.
Sensor Type Readings Delta Check Delta Transmit Interval
if delta not met
Water Sensing any change every minute 3 minutes
Low Battery Indicator
• When the battery on the water leak detector needs to be replaced, the LED will flash once every second for 5 seconds,
every 30 seconds, and a push notification will notify you of the low battery.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
2
Loading...