Kyocera TASKalfa 250, TASKalfa 552ci, TASKalfa300, TASKalfa400, TASKalfa500ci SERVICEBULLETINS 2H7 051

Service Bulletin

SB Number:

Subject:

SB 2H7-051

Latest maintenance modes and initial values

Creation Date: 08/06/2011

Model: TASKalfa250ci/300ci/400ci/500ci/552ci

Contents

The table below describes the latest information as of May 2011, with regards to the latest Maintenance mode
items and the revised initial values which are not described in the Service Manual. Please note that the

descriptions in the Service manual, are based on the latest Firmware version (TASKalfa250ci/300ci/400ci/500ci
Firmware pack 11.00 and TASKalfa552ci Firmware pack 5.00).

Maintenance mode table (Grey indicates the maintenance mode is applicable to the model)

No. Contents 250ci/

300ci

108 Set Separation Shift

Bias

147 Set Toner Apply

Mode

206 Set Coin Vender

Mode

340 Setting the applied

mode

464 Set ID Adjustment

Mode

*1: Only the maintenance mode table is revised (The initial value is 70 in the individual maintenance mode detail
section)

1 Set Output Value

2 Set Timing 1 On Timing Lead

2 On Timing Center

3 OFF Timing 110 70 *1 40

1 :

2 Set Operation Mode 1 MODE0/MODE1/MODE2 MODE0 <- <-

3 Upper Limit 1 Upper limit 3.5 <- <-

:

3 BK Density 1 <-

No Coin Action 1 ALL CLEAR OFF <- <-

2 AUTO CLEAR

3 OFF

1 ImageMemory Adj 1 <- <-

2 ImageMemory Adj

Detail

AC Calibration <-A

High Altitude <-B 1 MODE1/MODE2 MODE1 <- <-

190 <- <-

400ci/
500ci

552ci

Additional items at maintenance mode U464 (Marked in Blue)

Warmup Calib Type only appears in

the case of the TASKalfa250ci/300ci

KMIS Service Department, Kyocera Mita Europe B135 / SB 2H7-051

Page 1 of 1