Kyocera FS-C8500DN SERVICEBULLETINS 2KA-014

Service Bulletin

SB Number:

Subject:

SB 2KA-014

Latest maintenance modes and initial values

Creation Date: 08/06/2011

Model: FS-C8500DN

Contents

The table below describes the latest information as of May 2011, with regards to the latest Maintenance mode
items and the revised initial values which are not described in the Service Manual.

Please note that the descriptions in the Service manual, are based on the latest Firmware version (Firmware pack

5.00).

Maintenance mode table (Grey indicates the maintenance mode is applicable to the FS-C8500DNl)

No. Contents

010 Set Maintenance Mode ID 1 New ID

2 New ID (Reconrm)

3 Initialize

108 Set Separation Shift Bias 1 Set Output Value

2 Set Timing 1 On Timing Lead

2 On Timing Center

3 OFF Timing <-

147 Set Toner Apply Mode 1 :

2 Set Operation Mode 1 MODE0/MODE1/MODE2 <-

3 Upper Limit 1 Upper limit <-

:

3 BK Density <-

206 Set Coin Vender Mode No Coin Action 1 ALL CLEAR

340 Setting the applied mode 1 ImageMemory Adj

2 ImageMemory Adj Detail

464 Set ID Adjustment Mode AC Calibration <-A

High Altitude <-B 1 MODE1/MODE2 <-

Additional items at maintenance mode U464 (Marked in Blue)

2 AUTO CLEAR

3 OFF

KMIS Service Department, Kyocera Mita Europe B135 / SB 2KA-014

Page 1 of 1