Kyocera FS-6025, FS-6030MFP Service Bulletin 2K3 0014 B185
jecting to
as shown
on
left.
Service Bulletin Ref. No.
Subject
(Page.1/2)
2K3-0014 (B185)
<Date> June 30, 2011
Improvement of the Paper Stacking Ability When E
the Upper Tray
Model
FS-6030MFP, FS-6025MFP, FS-6025MFP/B
Topic
Depending on the condition of the paper printed in duplex, curled paper might push the sheet ejected before, and
the page order might not be correct in case that a large volume of paper was ejected with the bridge unit attached.
Therefore, the following change was made.
*The phenomenon described above does not occur in case of simplex printing.
Content of Changes
1) A stopper (No.1) was attached to the upper part of the inner tray in order to prevent the paper from being
pushed out. This stopper was registered as a service part.
<Stopper (No.1) attachment procedures>
Fig.1
<Note when using the stopper (No.1)>
- Pull down the stopper (No.1) when using the bridge unit.
- Pull up the stopper (No.1) when using the job separator.
<Stopper (No.1)>
(X: Stopper pulled down) (Y: Stopper pulled up)
Insert the rib at
the stopper part
into this hole so
that it will be fixed
(Alignment)
Metal plate
Cover
No.1
KYOCERA MITA Europe B.V.
European Service & Development Center (ESDC)
Stopper
(Shaded area: Double-sided tape)
A
No.1
B
<Attachment procedures>
1) Take the bridge unit out.
2) Attach the stopper (No.1) aligning to A and B above.
3) Pull up the stopper (No.1) and attach the bridge unit.
Metal plate
Cover
Q’
Com
bi
p
ati-
Service Bulletin Ref. No.
<Date> June 30, 2011
(Page.2/2)
2K3-0014 (B185)
No.
KMC’s Classification Entire Stock Rework In-Field modification at next visit
Field Measure:
Please attach the stopper (No.1) in case that the duplex pages are ejected in the wrong order. Please refer to
the bundled leaflet for the attachment procedure.
Serial Nos. of the Affected Machines: As this is a service part, no serial number information is available.
Old Part
No.
1 ----------
New Part
No.
302K394860
2K394860
Description
PARTS STOPPER PAPER C
ASSY SP
In-Field modification by case No modification necessary
ty
Old New Old New
- 1
lity
- O
Remarks
European Service & Development Center (ESDC)
KYOCERA MITA Europe B.V.
Loading...