Kyocera DF-730 SERVICEBULLETINS 3JY-003
Service Bulletin
SB Number:
SB 3JY-003
Creation Date: 17/04/2008
Subject: System rmware upgrade version 002.009
Model: DF-730
Contents of
changes
Latest rmware
for KM-2560/3060/
2540/3040 as of
October 2007
Item Contents
1 Abnormal noise from
reverse section.
2 Motor alignment error
C8170.
Type Program No. Check SUM Version Status Date
MAIN (IPU) 5H1_9200.002.009 0454 002.009
The nisher reverse roller activates before paper has
completely gone through the last roller of the machine.
Therefore the timing has been changed so that the DF-730 feeds
the paper after it has completely passed the last roller of the machine.
After Jam 81 the Print job does restart, however an alignment
motor error could occur when the rst sheet of the restarted print
job ejects from the machine to the DF-730.
This is because the alignment motor stops, instead of
initializing after Jam 81.
Note See SB 3JY-002 if it is necessary to replace PBA-CONT-F
Parts No. Old Parts
No.
1 305H180021
5H180021
Classication
Field measure When above mentioned phenomena occurs, please upgrade the rmware to the newest version.
Affected serial
numbers
Entire stock rework
Type Serial number
DF-730 PRK7X00001 and higher
New Parts
No.
305H180022
5H180022
In-eld modication at next visit
Description Q’TY Interchange-
PBA-CONT-F 1 1 X O O
Old New Old New
In-eld modication by case
X
ability
No modication necessary
SP
KMIS Service Department, Kyocera Mita Europe 8266 / SB 3JY-003
Page 1 of 1
Loading...