Kohler K-5024-T Installation Manual

Installation

Guide

Urinal

K-5024–T

M product numbers are for Mexico (i.e. K-12345M)
Los números de productos seguidos de
M corresponden a México (Ej.
K-12345M)
Français, page “Français-1”
Español, página “Español-1”

1002334-2-B

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don’t
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.

Before You Begin

Observe all local plumbing and building codes.

Refer to local codes and manufacturer’s instructions for flush valve
requirements.

Carefully inspect the new urinal for damage.

CAUTION: Risk of personal injury or product damage. Handle
with care. Vitreous china can break or chip if the product is
handled carelessly.

Fixture dimensions are nominal and conform to tolerances by ANSI
Standard A112.19.2M.

Site preparation may require additional tools and hardware.

1002334-2-B 2 Kohler Co.

Roughing-In Dimensions

•

* The urinal complies with ADA requirements when the rim is
mounted no higher than 17” (43.2cm) from the finished floor.

1. Preparation

Turn the water supply off.
Install or relocate the supply tubing and waste pipe as necessary to

conform to the roughing-in dimensions.
Install the shut-off valve.
Install adequate support framing as needed.

Kohler Co. 3 1002334-2-B

2. Install the Urinal

Install the hangers according to the roughing-in illustration.

NOTE: Wall hangers must be installed to a secure surface as shown
in hanger screw location.

Mark the anchor hole locations on the wall according to the
roughing-in illustration. Make sure the holes are level.

Drill pilot holes in the center of each hole mark.
Thread a nut onto the hanger screws, and install the coarse-threaded

end of the hanger screws into the pilot holes. Use an adjustable
wrench to turn the hanger screws into the support framing so the
coarse threads are fully engaged.

CAUTION: Risk of personal injury or product damage. Handle
with care. Vitreous china can break or chip if the product is
handled carelessly.

Carefully position the urinal over the hanger screws and onto the
wall hanger.

CAUTION: Risk of product damage. Do not overtighten the
screws.

Secure the urinal with the washers and nuts.

1002334-2-B 4 Kohler Co.

3. Complete the Installation

Install the flush valve according to the manufacturer’s instructions.
Connect the water supply and complete the waste pipe connections.
Install the tailpiece and P-trap.
Turn on the water supply.
Flush and check the entire installation for leaks.
Repair as needed.

Kohler Co. 5 1002334-2-B