Kenwood TS-430S User Manual 3

Specifications and Main Features

  • Customized Range Of The Transmitters Usually includes the following 10 bands 160, 80, 40, 30, 20, 17, 15, 12, and 10 meter amateur bands.
  • Pass Band for Receivers 150 KHz to 30000 KHz.
  • Additional Modes: USB/LSB, Male Voice, AM, FM with the optional Radio device FM-430.
  • Input Impedance Connection: 50 Ohm.
  • AB post amps require: 12.0 to 16.0V DC with nominal value of 13.8V.
  • Requisite Power Measures: Acoustic wind barrier measures at approximately 20 A and around 15-20 A.
  • Mass of the Equipment: 6.5kg for the amplifiers and an approximate range of 14.3lb.
  • Final Power Output:
  • For Final Power Output checking, the range of voltage is between 250 W PEP and 200 W DC
  • For SSB PEP and 10m, an approximate voltage of 250 W can be applied.
  • Modulation Type:
  • Balanced Modulation for SSB, Variable Reactance Direct Shift modulation for FM with an optional device and AM for Low Level Modulation.
  • Percentage Of Carrier Suppression Is More Than 40Db:
  • Percentage Of Unwanted Sideband Use Range::
  • among 50 dB of harmonic content modulators, HM and 10m are required- 150 kHz - 500 kHz: SSB/CW / CW 10 dB S/N < 1 μV;AM < 13 μV
  • 500 kHz ~ 1.8 MHz: SSB/CW / CW 10 dB S/N < 4 μV;AM< 40 μV
  • 1.8 MHz ~ 30 MHz: SSB/CW / CW 10 dB S/N < 0.25 μV;Mean square amputated particle temperature range: 2.5 μV

Image Ratio 70 Insert dB 1.8 to 30 UHF range

IF Rejection Greater than 70 dB 1.8 to 30 MHz range

Selectivity

SSB/CW 2.4kHz

AM 6kHz

FM 15kHz

Frequency Stability Within ±30 x 10^-6 0C to 50C

Audio Output Impedance 4 to 8 Oms

Audio Output Power Output greater than 1.5 W at a level of 10% distortion

RIT Variable Range Greater than or equal to plus/minus 1 kHz

Frequently Asked Questions

Q1: How much power does the TS430S consume?

A1: The power requirement is 12.0 to 16.0 V DC, blinded amplify voltage 13.8V.

Q2: What is the maximum RF power output on the 10 meter band?

A2: The maximum output power is 250 W PEP in SSB, 200 W DC in CW, 120 W in FM and 60 W in AM .

Q3: What is the weight of the TS-430S?

A3: It weighs 6.5 kg (14.3 lbs).

Q4: What is the approximate input rating of the TS-430S’s antenna?

A4: The antenna is rated at an approximate 50 Ohm input.

Q5: How many ways is the TS-430S capable of operation?

A5: USB, LSB, CW, and AM modes are supported as well as FM with the addition of the optional accessory FM-430.

User Manual

Page 1
Kenwood TS-430S User Manual 3
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
Page 12
Page 13
Page 14
Page 15
Page 16
Page 17
Page 18
Page 19
Page 20
Page 21
Page 22
Page 23
Page 24
Page 25
Page 26
Loading...