KDW60X10_60W10_IB_final110317.indd 317/03/2011 10:18 AM
Thank you for purchasing your new Kenwood Freestanding Dishwasher.
These operating instructions will help you use it properly and safely.
We recommend that you spend some time reading this installation/instruction
manual in order that you fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep this installation/
instruction manual for future reference.
unpacking
Remove all packaging from the unit. Retain the packaging. If you dispose of it please do so
according to local regulations.
The following items are included:
The Main Unit
Detergent Measuring Spoon x 1
1 full spoon = 20g (approx.)
P.N.: 673002200079
Salt Funnel X 1
P.N.: 673002200043
Cutlery Basket
P.N.: 673002200019
and 673002200024
Measuring Cup X 1
60ml (approx)
P.N.: 673006200004
U-shape Hose Holder X 1
P.N.: 673006200003
If items are missing, or damaged please contact Partmaster (UK only).
Tel: 0844 800 3456 for assistance.
Normal Supply Hose X 1
P.N.: 673000900060
Condensation Strip X 1
P.N.: 675001300715
Instruction Manual X 1
P.N.: KDW60X-W10-002
4
KDW60X10_60W10_IB_final110317.indd 417/03/2011 10:18 AM
600
600
unit in mm
850
30
850
600
620
min.100
80
level
level
level
level
installation
installation
location
When selecting a position for your
freestanding dishwasher you should make
sure the installation surface is flat and
firm, and the room is well ventilated. Avoid
locating your dishwasher near a heat source,
eg. cooker, boiler or radiator. Extreme cold
ambient temperatures may also cause the
appliance not to perform properly. This
dishwasher is not designed for use in a garage
or outdoor installation.
Do not drape the dishwasher with any
covering. When installing, ensure that free
space is left at the sides.
All parts removed must be saved to
do the reinstallation in the future.
Ensure the dishwasher is unplugged
and empty. We recommend that 2
people handle the dishwasher during
installation.
1. Please ensure the dishwasher is installed
by a qualified technician. Refer to the tools
required.
2. Ensure there is clearance each side of the
unit to allow slight sideways movement for
servicing when required. Good levelling is
essential for correct closure and sealing
of the door. When the unit is correctly
levelled, the door should not catch the
inner liner on either side of the cabinet.
The adjustable feet may be loosened or
tightened in order to obtain the optimum
levelling of the unit.
KDW60X10_60W10_IB_final110317.indd 517/03/2011 10:18 AM
5
installation
3. If required, the worktop of the dishwasher
can be removed. The height without
the worktop is 820 mm, the minimum
dimensions required to accommodate the
dishwasher within fitted kitchen furniture
units.
Do not connect the unit to the mains socket
before installation. Ensure you are not
installing the unit right in front of the mains
socket. This is to avoid potential damage to
the back of the unit.
4. The condensation strip must be fitted
to the underside of the worktop above
your dishwasher to protect it against any
moisture. Its purpose is to protect your
worktop’s underside from steam rising from
the dishwasher.
• Ensure the surface is clean prior to
sticking the condensation strip to the
underside of the worktop.
• Remove the backing paper from the
condensation strip.
• Stick the condensation strip to the
underside of the worktop.
Failure to attach the condensation
strip could result in damage to the
underside of your worktop!
5. The worktop can be removed by removing
the fixing screws located at the front of the
dishwasher. After removing the screws,
push the cover forward, then lift it away
from the dishwasher.
6
Stick the Condensation Strip
under the worktop, where you
want to install the dishwasher.
Unscrew
Leave some space
Remove the worktop
Step 2
Push forward
Step 1
KDW60X10_60W10_IB_final110317.indd 617/03/2011 10:18 AM
installation
6. Position the dishwasher next to a water
tap and a drain. Ensure the water inlet and
drain hoses are not kinked or squashed.
The unit must not stand on the mains
cable.
7. Make sure your plumbing is suitable for
use with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using
the new water inlet hose. OLD HOSE
SETS MUST NOT BE RE-USED. The
water pressure from the water mains
needs to be at a minimum of 0.04 MPa and
a maximum of 1.00MPa.
• Connect one end of the safety water
supply hose to your dishwasher, and
then connect the other end of the hose
to your water mains. Please ensure the
black rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
You may use a Y-adaptor (not included)
for an additional water feed for another
appliance, for example a washing
machine. This is only applicable for
cold water mains. A Y-adaptor is
available from most DIY stores.
water mains
Y-Adaptor
(not included)
Connect to
another
appliance
safety water supply hose
if required.
• Do not bend your drain hose.
7
KDW60X10_60W10_IB_final110317.indd 717/03/2011 10:18 AM
installation
ST4 screws
• You may use the U-shaped drain hose
holder to secure your drain hose and to
avoid bending it.
• Secure the water drain hose to the
waste pipe to avoid it coming off during
the washing process.
U-shaped drain hose
holder
water drain hose
The waste pipe must only be connected
to the foul drains and not the surface
water drainage system. The water drain
hose should be placed between 40 cm
and 100 cm from the floor level and
must not be extended, otherwise the
unit may not be able to expel the waste
water properly.
8
KDW60X10_60W10_IB_final110317.indd 817/03/2011 10:19 AM
product overview
front view
1
2
3
rear view
1. control panel
2. door handle
4
4. drain hose
5. water inlet
(connect to supply hose)
3. display screen
5
6
6. mains cable
(connect to electrical mains outlet)
9
KDW60X10_60W10_IB_final110317.indd 917/03/2011 10:19 AM
upper basket
7
7
7. cup racks8. spikes
lower basket
8
internal view
8
9
10
11
9. spray arms (1 - under upper basket and
1 - under lower basket)
10. salt reservoir
11. detergent dispenser (dual compartment)
12
13
14
12. cutlery basket
13. filtering system
14. rinse aid dispenser
10
KDW60X10_60W10_IB_final110317.indd 1017/03/2011 10:19 AM
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.