Kawasaki VULCAN 1700 VOYAGER User Manual
Assembly Instructions
Description: CB Radio Kit Model: Vulcan 1700 Voyager
Part Number: K10400-037 Approximate
60 min.
Assembly Time:
Installation of this accessory should be performed by a qualied technician with the proper tools and
equipment.
If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to
complete the installation. Please note that Kawasaki cannot assume any responsibility for damage
resulting from incorrect installation.
Parts List Tools Required:
Seq. Description Qty Tool Description
1. CB Radio Module Assembly 1 Drill Motor
2. M6 x 30mm Bolts 2
3. CB Antenna Cable 1
4. CB Antenna Base 1
5. M6 x 20mm Philips Head Bolt 1
6. CB Ground Strap 1
7. M6 Lock Nuts 2
Scribe
1/16” Drill Bit
7mm (1/4”) Drill Bit
5mm Hex Head Driver
Socket Driver
10mm Socket
Philips Head Screwdriver
8. Lock Washer 1
9. Belleville Washer 1
10. M6 Cap Nut 1
11. Cable Ties, 6 inch 8
12. Cable Tie, 14.5 inch 1
13. CB Antenna Mast 1
14. Star Washer 1
Installation Instructions
Installation Preparation
Parts Removal
z Set bike securely on side stand on level ground. Switch off
ignition and remove key.
z Refer to the VN1700 Voyager Service Manual and remove the
fairing. Remove the front and rear seats, fairing and left fairing
lower cover (black piece).
z Open the trunk and remove the tray by pressing the center of
the four lock rivets.
z Remove the fuel tank mounting bolts and lift the tank to expose
the frame.
Installation
Install CB Module
z Mount the CB module using the two supplied 6 x 30mm bolts
on the top and re-using the lower bolt. Tighten all three bolts
rmly but do not over tighten as this may damage the plastic
fairing lower.
z Route the harness from the CB module behind the left engine
guard and into the left side of the fairing. Find the matching
multi-pin connector at the left side of the radio and connect to
the CB module harness. Press the connectors together rmly
to engage the waterproof seals. Secure the cables as needed
with provided cable ties.
NOTE
o If the optional XM Radio K10400-038 will also be installed,
a K10400-042 Splitter Cable (sold separately) will also be
needed to connect both XM and CB to the OE radio.
Install CB Antenna
z Connect the threaded end of the CB antenna cable to the right-
angle tting on the CB module and rmly hand tighten.
Loading...