section contains additional information.
are registered trademarks of
Alphanumeric Assignment of Remote Control Number Keys
Adding/Deleting Satellites
Alignment (Satellite Search)
A defective fuse should only be replaced by a fuse with the same rated value
yourself results in forfeiture of all warranty claims
Always turn off the unit at the power switch if you will be absent for a long time or there is a storm. This also applies
section contains a sample
January 2003 on used electrical and electronic
At the end of its service life, take this unit for disposal at a relevant
Controls, Displays and Connections
This section contains a brief description
of all controls, displays and connections.
Front View
Rear View
1
1
2
3
2
3
4
5
8
6
7
12
13
10
9
11
Front View Rear View
1
Power switch (ON/OFF)
2 Fuse 2 Turntable unit SAT-IF signal input
3 2 Common Interface slots for 2 CA modules 3 Receiver SAT-IF signal input(connected to “5”)
10
1
Connection for separate infrared receiver
4 RS 232 data interface
5 Turntable unit SAT-IF signal loop
output (connected to “3”)
6 SAF-IF signal loop output for receiver
7 Scart socket for TV connection
8 Mains voltage supply
9 Audio outputs, 2 cinch sockets, L+R channel
10 Video output (composite colour)
11
Dolby Digital data stream output (AC 3)
12 Power supply for turntable
13 Output for data connection to turntable
key to change between the two instruction
As supplied, instruction set 1 is always activated by default.
You can only operate the UFD 170 using the remote
parameters to be set are all highlighted in colour. The menus are
Alphanumeric Assignment of Remote Control Number Keys
and start satellite search with a different program-
After a successful search, you can select the factory-preset TV and
As soon as the turntable has found the correct satellite, the automatic
keys to exit the help display and return to
Video Text
in the programme display shows you whether video
key, the receiver processes the
After completion of the search, the video text broadcast by the relevant
After each change of programme, an on-screen display shows you the
An alternative method of selecting a different programme is to press
At the top left is a “+” for the complete list. In the column below it, you
(Lock) locks the channel shown
(Delete) deletes the channel shown
(Move) moves the channel to a different position
(Mode) selects the mode for the channel list
keys skip to the next programme, whereas the
keys skip to the next page. A selection is confi rmed with
, you exit the channel list, and return you to the previously
key to return to TV mode.
The procedure for all other programmes - including those with