JKS 2034 User Manual
Product: Quicker Disconnects™
Part Number: JKS2030 - JKS2034
INSTALLATION
Applications: Wrangler JK, 2007+
INSTRUCTIONS
517-278-1226 • tech@jksmfg.com • www.jksmfg.com
491 W. Gareld Avenue, Coldwater, MI 49036
Welcome
CONGRATULATIONS on purchasing a set of new
Quicker Disconnects™ from JKS Manufacturing. We
are committed to providing you with the best products
available and your satisfaction is our rst priority.
PLEASE READ these Installation Instructions carefully, and save them for future reference, as they contain
important installation and maintenance information.
Tools Required
Metric/Standard Socket Wrench Set
Torque Wrench
Medium Strength Threadlocker
#1 Philips Screwdriver or Small Punch
Angle Measuring Tool
15/16” Open-End Wrench
18mm & 19mm Open-End Wrenches *
Grease Gun with Zerk Fitting Coupler
Wheel Bearing Grease
Factory Service Manual (recommended)
* Asterisk denotes tools that are not required for some applica-
tions. Thoroughly read instructions rst to determine which tools
will be required for your application.
Parts
A
1/2" Nylock Nut
B
Offset Polyurethane Spacer
C
1/2" Upper Tapered Mounting Post (Long)
D
Spherical Bushing
E
Press-In Grease Zerk
F
Grease Zerk Cap
G
Upper Male Threaded End Assembly
H
5/8” Jam Nut
I
Lower Female Threaded End Assembly
J
Click Pin
K
1/2” Lower Tapered Mounting Post (Drv Side - Short)
L
1/2” Nylock Nut
M
1/2” Lower Flat Mounting Post (Pass Side)
JKS2030 - JKS2034JKS Quicker Disconect Installation
Page 1
Important Product
Safety Information
For your safety and the safety of others, please
read all instructions and warnings in this pamphlet
and your Jeep® owner’s manual and off road
driving supplement before attempting installation.
Within these instructions the following signal words
refer to important product safety information:
WARNING
Indicates hazards or unsafe situations which could
result in severe personal injury or death.
CAUTION
Indicates hazards or unsafe situations which could result in property damage or minor to moderate personal
injury.
NOTICE
Careful attention is required to this operation that gener-
ally does not relate to personal injury, although damage
to your JKS product or other property may result if you
fail to follow instructions.
To reduce risk of serious injury and accident:
 Choose modications that balance your actual
highway & off-road use.
 Avoid sharp turns, abrupt maneuvers or steep
side-cambers.
 Avoid other maneuvering conditions which may
cause the vehicle to trip, roll, lose traction or compromise your ability to safely brake in an emergency.
 Routinely inspect your vehicle components for un-
usual wear or off-road damage. Repair or Replace
any unserviceable components before use.
 Do not modify or combine body lifts with other me-
chanical lifts contrary to manufacturers’ or Jeep®
recommendations & warnings.
 Acquaint any other drivers with your vehicle modi-
cations and handling.
 Always wear seat belts and/or appropriate off-road
restraints, reduce your speed, Tread Lightly©.
Important
NOT COMPATIBLE WITH aftermarket swaybars.
Install product with Original Equipment swaybar only.
SOME VEHICLES MAY REQUIRE extended front
brake hoses or other modications to compensate for
additional suspension travel.
WARNING
Higher Rollover Risk
Modifying your Jeep® to improve off-road performance may result in vehicle handling different than as
factory equipped, including increased ride-height and/
or chassis articulation; reduced lateral stability and
higher risk of roll-over or other accident. Also, owner’s
choice of larger tire and wheel combinations may
require additional braking force or increased stopping
distances.
NEVER DISCONNECT swaybar when operating
vehicle on public roads.
WHEN DISCONNECTED, the Quicker Disconnects
must be completely removed from vehicle, and the
swaybar must be secured to the chassis in the hori-
zontal position to prevent interference with tires.
WARNING
Stay Connected On-Road
On-highway safety is enhanced by controlling body
roll. Never disconnect swaybar when operating on
public roads.
WARNING
To assure intended performance JKS® Quicker Disconnects™ are NOT COMPATIBLE with aftermarket
Swaybars. Install ONLY with Jeep® factory sway bar.
On-highway safety is enhanced by controlling body
roll. Never disconnect swaybar when operating on
public roads. When disconnected off-road, swaybar
Page A
JKS2030 - JKS2034
JKS Quicker Disconect Installation
Loading...