Jensen JCR-230 User Manual

USER MANUAL

DUAL ALARM CLOCK RADIO

WITH AUTO TIME SET

PLEASE READ THIS USER MANUAL COMPLETELY

BEFORE OPERATING THIS UNIT AND RETAIN

THIS BOOKLET FOR FUTURE REFERENCE.

JCR-230

GB - 1

WARNING

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR
SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

The li g htni n g flash w i th
arrowhead symbol, within
an e quilateral tri angle is
intended to alert the user to
the presence of uninsulated
‘dangerous voltage’ within the
product’s enclo-sure that may

be of sufcient magnitude to

constitute a risk of electric
shock to persons.

C A U T I O N : T O R E D U C E
TH E RI SK O F EL E C T R I C
SHOCK DO NOT RE M OVE
C O V E R ( O N B A C K ) , N O
USER SERVICEABLE PARTS
INSIDE REFER SERVICING
TO Q U AL I FI E D SE RV I CE
PERSONNEL.

The exclamation point within
an e quilateral tri angle is
intended to alert the user to
the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.

WARNING

RISK OF ELECTRIC SHOCK DO

NOT OPEN

CAUTION:

Use of controls or adjustments or performance other than those specied may result in

hazardous radiation exposure.

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Cleaning – Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Clean only with a dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other

apparatus (including ampliers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wider or the third prong is provided for your
safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments/accessories specied by the manufacturer.

12. Use only with a cart, stand, tripod, bracket, or table specied by the

manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/ apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for long periods of
time.

14. Refer all servicing to qualied service personnel. Servicing is required when the apparatus

has been damaged in any way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.

15. This apparatus shall not be exposed to dripping or splashing water and that no object

lled with liquids such as vases shall be placed on the apparatus.

16. Mains plug is used as disconnect device and it should remain readily operable during
intended use. In order to disconnect the apparatus completely, the mains plug should
be disconnected from the mains socket outlet completely.

17. Battery shall not be exposed to excessive heat such as sunshine, re or the like.

18. The marking information is located at the bottom of the apparatus.

19. The Caution Marking is located at the bottom of the apparatus.

20. Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.

GB - 2

This symbol indicates that this product incorporates double
insulation between hazardous mains voltage and user
accessible parts

CAUTION:

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF AC PLUG TO WIDE
SLOT. FULLY INSERT.

COMPLIANCE WITH FCC REGULATION

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:

GB - 3

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

- Consult the dealer or an experienced radio/TV technician for help.

WARNING

Changes or modications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

Selecting ne audio equipment such as the unit you’ve just purchased is only the start

of your musical enjoyment. Now it’s time to consider how you can maximize the fun
and excitement your equipment offers. This manufacturer and the Electronic Industries
Association’s Consumer Electronics Group want you to get the most out of your
equipment by playing it at a safe level. One that lets the sound come through loud and
clear without annoying blaring or distortion and, most importantly, without affecting your
sensitive hearing. Sound can be deceiving. Over time your hearing “comfort level” adapts
to higher volumes of sound. So what sounds “normal” can actually be loud and harmful to
your hearing. Guard against this by setting your equipment at a safe level BEFORE your
hearing adapts.

DEAR JENSEN® CUSTOMER

To establish a safe level:

• Start your volume control at a low setting.

• Slowly increase the sound until you can hear it comfortably and clearly, and without
distortion.

Once you have established a comfortable sound level:

• Set the dial and leave it there.
Taking a minute to do this now will help to prevent hearing damage or loss in the future.
After all, we want you listening for a lifetime.

We Want You Listening For a Lifetime

Used wisely, your new sound equipment will provide a
lifetime of fun and enjoyment. Since hearing damage from
loud noise is often undetectable until it is too late, this
manufacturer and the Electronic Industries Association’
s Consumer Electronics Group recommend you avoid
prolonged exposure to excessive noise.

Customer’s Record:

The serial number of this product is found on its bottom cover. You should note the serial
number of this unit in the space provided as a permanent record of your purchase to aid

in identication in the event of theft of loss.

Model Number: JCR-230 Serial Number: