Invacare IV-O2 1487, IV-O2 1496, IV-O2 T1496 User Manual

I.V./O2 Cylinder Holder Accessory Kit

Assembly, Installation and Operating Instructions

Model Nos. 1487,1496 and T1496

NOTE: Check all parts for shipping damage. If ship­ping damage is noted, DO NOT use. Contact Dealer/
Invacare for further instructions.

SAFETY SUMMARY

The following recommendations are made for the
safe installation of the IV/O2 Cylinder Holder
Accessory Kit:

WARNING

DO NOT assemble or use this equipment
without first reading and understanding
this instruction sheet. If you are unable to
understand the Warnings, Cautions or In­structions, contact a healthcare profes­sional, dealer or technical personnel if ap­plicable before attempting to install this
equipment - otherwise, injury or damage
may occur.

After ANY adjustments, repair or service
and BEFORE use, make sure all attach­ing hardware is tightened securely.

Follow the Oxygen Cylinder manufactur­ers guidelines for proper usage of the oxy­gen cylinder.

INSTALLING IV/O2 CYLINDER
HOLDER (FIGURE 1)

NOTE: IF rear step tube is 7/8-inch diameter tubing, in­stall the long tube guide insert into the rear step tube be­fore installing the IV/O2 cylinder holder.

1. Place the IV/O2 cylinder holder and slide it onto the
rear step tube of the wheelchair.

NOTE: IF rear upright tubing is 7/8-inch diameter tub­ing, install the short tube guide insert over the rear
upright before installing and securing the IV/O2 cylin­der holder bracket.

2. Push the bracket of the IV/O2 cylinder holder over the
rear upright of the wheelchair and secure in place with
the hex screw, spacer and locknut.

3. Secure IV/O2 cylinder holder to push handle using a
ty-wrap.

4. Loosen the short adjustment knob to move IV/O2
cylinder holder to desired height and then retighten.

5. Use the long adjustment knob on the IV/O2 cylinder
holder bracket to secure the oxygen cylinder in place.

IV/O2 Cylinder Holder

Ty-wrap

Push

Handle

Short

Adjustment

Short

Knob

Tube

Guide

Insert

Rear

Upright

Spacer

Long

Adjustment

Rear Step

Knob

Tube

Long Tube Guide

Insert

FIGURE 1 - INSTALLING IV/O2 CYLINDER

Hex

Screw

HOLDER

Bracket

Locknut

Invacare Corporation www.invacare.com

USA Canada

One Invacare Way 5970 Chedworth Way Invacare® and Yes, you can. are trademarks of Invacare
Elyria, Ohio USA Mississauga, Ontario Corporation.
44036-2125 L5R 3T9, Canada © 2000 Invacare Corporation
800-333-6900 905-890-8838 Form No. 91-201 Part No. 1027931 Rev E (1) 12/00