Intermec CK1 Instructions Manual

Specifications

Design and specifications are subject to change without notice.

Physical Specifications

Product: Battery (P/N 073659)

Dimensions: 53.4 x 35.6 x 7.3 mm (2.1 x 1.4 x 0.3 in)

Weight: 24 g (0.9 oz)

Capacity and Output Specifications

Output: 3.7V

Capacity: 1050 mAh

Temperature Specifications

Operating temperature:

-10°C to 50°C (14°F to 122°F)

Charging temperature:

5°C to 45°C (41°F to 113°F)

Storage temperatures:

For up to one month

-20°C to 45°C (-4°F to 113°F)

For up to six months

-20°C to 35°C (-4°F to 95°F)

Humidity Specifications

Operating humidity: 10% to 95% non-condensing

Storage humidity: 0% to 95% non-condensing

6001 36th Avenue West
Everett, Washington 98203
U.S.A.

tel [phone]
fax [phone]

www.intermec.com

©

2005 Intermec Technologies

Corporation. All rights reserved.

CK1 Battery Instructions

*073775-002*

P/N 073775-002

CK1 Battery Instructions

The battery (P/N 073659) is a 1050 mAh lithium-ion battery
designed for use in the CK1 Handheld Computer. Before using the
battery, please read these instructions thoroughly and keep them for
future reference.

Replacing the Battery

1 Turn off the CK1, and place it face down on a flat, stable surface.

2 Push back the battery door latch, and pull up on the battery door.

Battery
door

Battery door
latch

3 Remove the battery door.

4 Aligning the battery contacts, insert the battery in the battery

compartment.

Battery
contacts

Battery
compartment

5 Insert the battery door.

If you fail to replace the battery immediately, you may
lose important data or applications.

Attention: Si la batterie n’est pas remplacée
immédiatement, des données ou applications
importantes risquent d’être perdues.

For best performance, keep a charged battery in the CK1.

Charging the Battery

Use the following table to understand the charging methods and
times. The charging times indicate the maximum amount of time to
charge a fully discharged battery. It may take less time to charge the
battery depending on the state of the battery charge.

Charging Methods and Times

Method Time

Battery Charger (P/N 073660) 4 hours

Multi-Dock (P/N 073667) 4 hours

Serial Dock (P/N 073665) 4 hours

Modem Dock (P/N 073666) 4 hours

Note: The charging times are at 21°C (70°F). Charging
time will vary depending on temperature.

You must fully charge your battery prior to using it in a CK1.
You can charge a battery after partial discharge without affecting the

original battery capacity.

Use only the methods described in this instruction sheet
to recharge the battery. Recharging this battery with any
other charger could result in damage to the battery.

Attention: Utilisez seulement les méthodes décrites dans
cette feuille d’instructions pour recharger le bloc­batterie. Ne pas recharger cette batterie avec un autre
type de chargeur car cela risque d’endommager la
batterie.

Important Recommendations

• Charge the battery immediately before use or within a couple of
days of use.

• Do not short circuit the battery and keep it away from metallic
items.

• Do not disassemble, open, or modify the battery.

• Do not expose the battery to excessive heat or fire.

• Do not store the battery at temperatures above 45°C (113°F),
such as inside a car on a hot day or in direct sunlight, as this may
damage the battery.

• Do not immerse the battery in water or get the battery wet.

• Do not solder directly to the battery contacts.

• Use the battery only with a CK1. Use of this battery in other
applications could result in damage to the device or battery.

• For maximum battery efficiency, the temperature range for
charging batteries is 5°C to 45°C (41°F to 113°F).

• Keep the battery contacts clean and free of dust and dirt.

• Do not recharge batteries in locations that are extremely hot or
cold, dusty or dirty, very humid, or subject to vibration.

Disposing of the Battery

When the battery reaches the end of its useful life, the spent
battery should be disposed of by a qualified recycler or
hazardous materials handler. If you are unsure of how to
properly dispose of this battery, contact your local Intermec
office for disposal information.

• Discarded batteries may create a safety hazard. Before disposal,
cover the battery contact terminals with electrical insulating tape.

• Keep away from children.

• Do not disassemble or dispose of in fire.

• Do not mix these batteries with the solid waste stream. (Required
in European countries.)