FIRMWARE UPGRADE PROCEDURE (DBS30.2) using upgrade disc:
1. Download the upgrade zip file. Extract the .bin file from the zip file and write it
on a CD (data disc).
2. Turn on the BD player. Wait until “NO DISC” is displayed on the front display.
3. Make sure to connect the player to a monitor to display video.
4. Press “Setup” button on the remote control. You will see following screen on the
monitor.
5. Use button on remote control to select and then press “Enter”
button. You will see following screen.
6. Use to select and press “Enter”. You will see following.
7. Scroll down by using
8. Press “Enter” button. Next, use to select “Disc update”. You will see
following screen.
to select “Software Update”.
9. Press “Enter” button and use to select “Yes”.
10. Press “Enter” button. You will see following screen:
11. Place the upgrade disc and close the tray. You will see following:
12. After a few minutes, you will see following screen. Use to select “Yes” on
the screen.
13. Press “Enter” button. You will see following screen.
14. After a few minutes, you will see following screen.
15. During the above upgrade you will see following on the front display of th e BD
player. The numbers will change and when it reaches 100/100, upgrade process
will be complete.
16. Do not interrupt updating process. The unit will turn off after completion of the
upgrade process and then turn back on again and will eject the upgrade disc. The
whole process may take around 10 to 15 minutes.
Loading...