Ingersoll-Rand VR910M, VR914M, IVES VR910M, IVES VR914M Installation Instructions Manual

INSTALLATION INSTRUCTIONS

VR910M/VR914M VANDAL RESISTANT TRIM

FOR USE WITH MORTISE DEVICES

PREPARE PUSH SIDE OF DOOR FOR EXIT

1

DEVICE. SEE EXIT DEVICE INSTRUCTIONS
FOR PREPARATION.

PREPARE PULL SIDE OF DOOR FOR TRIM.

2

A TRANSFER VERTICAL AND HORIZONTAL

DEVICE CENTER LINES FROM PUSH SIDE
OF DOOR TO PULL SIDE.

B LOCATE AND PREPARE ALL HOLES AS

INDICATED BELOW.

OUTSIDE FACE
OF LOCK STILE

11/16”

3-1/2”

RHR SHOWN

LHR OPPOSITE

1-3/8”

1-5/8” DIAMETER
HOLE (TRIM SIDE

OF DOOR) FOR

CYLINDERS ONLY

2-1/4”

INSTALL MORTISE LOCK. SEE MORTISE LOCK

3

INSTRUCTIONS.
INSTALL EXIT DEVICE AND TRIM.

4

VR910M/VR914M
TRIM

SCREWS (4):

10-24 X 1”
PPHMS SCREWS
(1-3/4” DOORS)

10-24 X 1-1/2”
PPHMS SCREWS
(2-1/4” DOORS)

INSTALL CYLINDER, IF USING.

5

SET SCREW: REMOVE FROM CYLINDER

SIDE UNTIL CYLINDER IS SCREWED INTO

PLACE, THEN REINSTALL SCREW

RHR

SHOWN

LHR

OPPOSITE

7”

3-1/2”

VERTICAL

DEVICE & TRIM

L

C

829560_00(2) Copyright © 2003 Ingersoll-Rand. All rights reserved.

DEVICE & TRIM

C

HORIZONTAL

L

13/32” DIAMETER HOLES,
4 PLACES (TRIM SIDE)
1/4” DIAMETER HOLES,
4 PLACES (OPPOSITE SIDE)

CYLINDER COLLAR

USE WAVE WASHERS

INSIDE CYLINDER

COLLAR AS NEEDED

FOR PROPER FIT

KEYHOLE

POSITION

WHEN INSTALLED