Ingersoll-Rand VON DUPRIN 35 Series, VON DUPRIN 33 Series, VON DUPRIN 98 Series, VON DUPRIN 99 Series Installation Instructions Manual

VON DUPRIN

®

INSTALLATION INSTRUCTIONS

33/35 & 98/99 SERIES END CAP RETROFIT KIT

PARTS LIST

#10-24 X 1-1/8 MTG. SCREW

END CAP

REMOVE OLD END CAP AND END CAP

1

MOUNTING BRACKET.

REMOVE OLD ANTI-RATTLE CLIP.

2

ANTI-RATTLE

CLIP

END CAP MOUNTING

BRACKET

ANTI-RATTLE CLIP

#10-16 X 3/8

T-CUT SCREW

INSTALL NEW MOUNTING BRACKET AND

4

END CAP.

VERIFY ALL EDGES ARE ALIGNED PROPERLY

5

AND ARE FREE OF BURRS.

#10-24 X 3/4 MTG. SCREW

INSTALL NEW ANTI-RATTLE CLIP.

3

2

MINIMUM

ANTI-RATTLE

CLIP INSIDE

911390_00(1) Copyright © 2001 Ingersoll-Rand Company. All rights reserved.

!

IF DEVICE HAS BEEN CUT TO FIT DOOR, CUT MUST BE

SQUARE FOR PROPER END CAP FIT. IF DEVICE HAS

NOT BEEN CUT SQUARE, IT MAY BE NECESSARY TO

REMOVE DEVICE FROM DOOR AND MAKE A CLEAN

NOTE

CUT FOR PROPER END CAP ALIGNMENT.

IF NEW END CAP HAS A GAP AS SHOWN BELOW ( ):

THE FOLLOWING METHOD CAN BE USED TO HELP CORRECT IT.

THIS METHOD WORKS ON 98/99 SERIES DEVICES.

A

A

GAP

REMOVE END CAP AND LOOSEN TWO END CAP

B

MOUNTING BRACKET SCREWS.

SLIDE MECHANISM CASE TOWARD END CAP

D

BRACKET UNTIL IT STOPS AGAINST BRACKET.
TIGHTEN TWO SCREWS.

VERIFY THAT
MECHANISM
CASE AND END
CAP BRACKET
HAS NO GAP

REINSTALL END CAP AND VERIFY THAT GAP IS

E

CLOSED AND ALL EDGES ARE FLUSH.

REMOVE CENTER CASE COVER AND LOOSEN TWO

C

MECHANISM CASE SCREWS. SLIDE CASE TOWARD
END CAP AS SHOWN.

CENTER CASE
COVER

2

MECHANISM
CASE

TIGHTEN TWO MECHANISM CASE SCREWS AND

F

REINSTALL CENTER CASE COVER.