INDESIT IS5G1KMW/U User Manual

User manual

Free-standing cooker

IS5G1KMW/U

IS5G1KMW/U IS5G1KMW/U

Contents

Safety Instructions, 2
Description of the appliance, 6

Installation tips, 7

Start-up and use, 10
Care and maintenance, 13

Installation, 15

EN

SAFETY INSTRUCTIONS

IMPORTANTTO BE READ ANDOBSERVED

These instructions are valid if the country
symbol appears on the appliance. If the symbol
does not appear on the appliance, please refer to
the technical instructions which will provide the
necessary instructions concerning modification of
the appliance to the conditions of use of the
country.

CAUTION : Use of the gas cooking appliance
results in the production of heat, moisture and
products of combustion in the room in which
it is installed. Ensure that the kitchen is well
ventilated, especially when the appliance is in
use: keep natural ventilation holes open or
install a mechanicalventilationdevice(mechanical
extractor hood). Prolonged intensive use of the
appliance may call for additional ventilation, such
asopeningawindow, ormoreeffectiveventilation,
for example increasing the level of mechanical
ventilation (if possible).

Failure to follow the informationin this manual exactly maycause a

fire or explosion, resulting in property damage or personal injury.

Before using the appliance, read these safety
instructions. Keep them nearby for future
reference.

These instructionsand the appliance itself provide
important safety warnings, to be observed at all
times. The manufacturer declines any liability for
failure to observe these safety instructions, for
inappropriate use of the appliance or incorrect
setting of controls.

WARNING: The appliance and its accessible
parts become hot during use. Care shoul be taken
to avoid touching heating elements. Children less
than 8 years of age must be kept away unless
continuously supervised.

WARNING : If the hob surface is cracked, do not

use the appliance – risk of electric shock.

WARNING : Danger of fire : Do not store items

on the cooking surfaces.

CAUTION : The cooking process has to be
supervised. A short cooking process has to be
supervised continuously.

WARNING: Leaving the hob unattended when

cooking with fat or oil can be dangerous – risk of
fire. NEVER try to extinguish a fire with water, but
switch off the appliance and then cover the flames
e.g. with a lid or a fire blanket.

Donot usethehob asa worksurfaceor support.
Keep clothes or other flammable materials away
from the appliance, unitl all the components have
cooled down completely – risk of fire.

Very young children (0-3 years) should be kept
away from the appliance. Young children (3-8
years) should be kept away from the appliance

unless continuously supervised. Children from 8
years old and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge can use this appliance
only if they are supervised or have been given
instructions on safe use and understand the
hazards involved. Children must not play with the
appliance. Cleaning and user maintenance must
notbe carriedoutby childrenwithout supervision.

CAUTION : In case of hotplate glass breakage:­shut immediately off all burners and any electrical
heating element and isolate the appliance from
the power supply; - do not touch the appliance
surface; -do not use the appliance

The glass lid can break in if it is heated up.
Turn off all the burners and the electric
plates before closing the lid. Do not shout
down lid when burner alight

WARNING: The appliance and its accessible
parts become hotduring use. Careshould be taken
to avoid touching heating elements. Children less
than 8 years of age must be kept away unless
continuously supervised

Never leave the appliance unattended during
food drying. If the appliance is suitable for
probe usage, only use a temperature probe
recommended for this oven - risk of fire.

Keep clothes or other flammable materials
away from the appliance, until all the components
have cooled down completely - risk of fire. Always
be vigilant when cooking foods rich in fat, oil or
when adding alcoholic beverages - risk of fire. Use
oven gloves to remove pans and accessories. At
the end of cooking, open the door with caution,
allowing hot air or steam to escape gradually
before accessing the cavity - risk of burns. Do not
obstruct hot air vents at the front of the oven - risk
of fire.

Exercise caution when the oven door is in the

open or down position, to avoid hitting the door.

PERMITTED USE

CAUTION: The appliance is not intended to
be operated by means of an external switching
device, such as a timer, or separate remote
controlled system.

This appliance is intended to be used in
household and similar applications such as: staff
kitchen areas in shops, offices and other working
environments; farm houses; by clients in hotels,
motels, bed & breakfast and other residential
environments.

No other useis permitted(e.g. heating rooms).

This appliance is not for professional use. Do

not use the appliance outdoors.

Do not store explosive or flammable
substances (e.g. gasoline or aerosol cans) inside or
near the appliance - risk of fire.

2

Use pots and pans with bottoms the same
width as that of the burners or slightly larger (see
specific table). Make sure pots on the grates do
not protrude beyond the edge of the hob.

Improper use of the grids can result in damage
to the hob: do not position the grids upside down
or slide them across the hob.

Do not let the burner flame extend beyond the edge of the pan
Do not use : Cast iron griddles, ollar stones, terracotta pots and pans.

Heat diffusers such as metal mesh, or any other types. Two burners
simultaneously for one receptacle (e.g. Fish kettle).

Should particular local conditions of the delivered gas make the ignition
of burner difficult, it is advisable to repeat the operation with the knob
turned to small flame setting.

In case of installation of a hood above the cooktop, please refer to the
hood instructions for the correct distance.

The protective rubber feet on the grids represent a chocking hazard for
young children. After removing the grids, please ensure that all the feet
are correctly fitted.

GAS CONNECTION

WARNING :Prior to installation, ensure that the
local distribution conditions (type of gas and gas
pressure) and the configuration of the appliance
are compatible.

Check that the pressure of the gas supply is
consistent with the values indicated in Table 1
(“Burner and nozzle specifications”).

WARNING : The configuration conditions of
this appliance are stated on the label (or data
plate).

WARNING : This appliance is not connected
to a combustion products evacuation device. It
must be installed and connected in accordance
with current installation regulations. Particular
attention must be paid to the relevant
requirements regarding ventilation.

If the appliance is connected to liquid gas, the
regulation screw must be fastened as tightly as
possible.

IMPORTANT : When the gas cylinder or gas
container is installed, it must be properly settled
(vertical orientation).

WARNING : This operation must be perfomed

by a qualified technician

Use only a flexible or rigid metal hose for the

gas connection.

Connection with a rigid pipe (copper or steel):
Connection to the gas system must be carried
out in such a way as not to place any strain of
any kind on the appliance. There is an adjustable
L-shaped pipe fitting on the appliance supply
ramp and this is fitted with a seal in order to
prevent leaks. The seal must always be replaced
after rotating the pipe fitting (the seal is provided
with the appliance). The gas supply pipe fitting is
a threaded 1/2 gas cylindrical male attachment.

Connecting a flexible jointless stainless steel
pipe to a threaded attachment: The gas supply
pipe fitting is a threaded 1/2 gas cylindrical male
attachment. These pipes must be installed so that
they are never longer than 2000 mm when fully

extended. Once the connection has been made,
make sure that the flexible metal pipe does not
touch any moving parts and is not compressed.
Only use pipes and seals that comply with current
national regulations.

IMPORTANT : If a staineless steelhose is used,it
must beinstalled soas not touch anymoving parts
part of the furniture (e.g. drawer). It must pass
through an area where there are no obstructions
and where it is possible to inspect it across its
entire length.

Theappliance shouldbe connectedto themain
gas supply or to a gas cylinder in compliance with
the current national regulations. Before making
the connection, make sure that the appliance is
compatible with the gas supply you wish to use.
If it is not, follow the instructions indicated in the
paragraph "Adapting to different types of gas".

After connection to the gas supply, check for
leaks with soapy water. Light up the burners and
turn the knobs from max position 1* to minimum
position 2* to check flame stability.

Connection to the gas network or the gas
cylinder may be carryout using a flexible rubber
or steel hose, in accordance with current national
legislation.

ADAPTING TO DIFFERENT TYPES OF GAS

To adapt the appliance to a type of gas
other than the type for which it was manufactured
(indicatedonthe ratinglabel), followthe dedicated
steps provided after the intallation drawings.

INSTALLATION

The appliance must be handled and installed
by two or more persons - risk of injury. Use
protective gloves to unpack and install - risk of
cuts.

The electrical and gas connections must

comply with local regulations.

Installation, including water supply (if any),
electrical connections and repairs must be carried
out by a qualified technician. Do not repair or
replaceany partofthe applianceunlessspecifically
statedin theusermanual. Keepchildren awayfrom
the installation site. After unpacking theappliance,
make sure that it has not been damaged during
transport. In the event of problems, contact the
dealer or your nearest Aftersales Service. Once
installed, packaging waste (plastic, styrofoam
parts etc.) must be stored out of reach of
children - risk of suffocation. The appliance must
be disconnected from the power supply before
any installation operation - risk of electric shock.
During installation, make sure the appliance does
not damagethe power cable - risk of fire or electric
shock. Only activate the appliance when the
installation has been completed.

WARNING : Modification of the appliance and

its method of installation are essential in order to

3

use the appliance safely and correctly in all the
additional countries

Use pressure regulators suitable for the gas

pressure indicated in the instructions.

The room must be equipped with an air
extraction system that expels any combustion
fumes.

Theroom mustalsoallow properaircirculation,

as air is needed for combustion to occur normally.
The flow of air must not be less than 2 m³/h per

kW of installed power.

The air circulation system may take air directly

from the outside by means of a pipe with an inner
cross section of at least 100cm²; the opening must

not be susceptible to blockages.

The system can also provide the air needed for
combustion indirectly, i.e. from adjacent rooms
fitted with air circulation tubes asdescribed above.
However, these rooms must not be communal
rooms, bedrooms or rooms that may present a fire
hazard.

Liquid petroleum gas sinks to the floor as it
is heavier than air. Therefore, rooms containing
LPG cylinders must also be equipped with vents
to allow gas to escape in the event of a leak.
This means that LPG cylinders, whether partially
or completely full, must not be installed or stored
in rooms or storage areas that are below ground
level (cellars, etc.). It is advisable to keep only the
cylinder being used in the room, positioned so
that it is not subject to heat produced by external
sources (ovens, fireplaces, stoves, etc. ) which
could raise the temperature of the cylinder above
50°C.

Should you find it difficult to turn the knobs for the burner, please
contact the After-sales Service, who can replace of the burner tap if
found to be faulty.

The openings use for the ventilation and dispersion of heat must never
be covered.

Do not remove the appliance from its polystyrene
foam base until the time of installation.

Donot install theappliancebehind adecorative

door - risk of fire.

if the range is placed on a base, it must
be leveled and fixed to the wall by the
retention chain provided, to prevent the
appliance slipping from the base.

WARNING: In order to prevent the
appliance from tipping, the retention chain
provided must be installed. Refer to the
instructions for installation.

ELECTRICAL WARNINGS

IMPORTANT : Information about current and
voltage consumption is provided on the rating
plate.

The rating plate is on the front edge of the
oven (visible when the door is open).

It must bepossible todisconnect theappliance

from the power supply by unplugging it if

plug is accessible, or by a multi-pole switch
installed upstream of the socket in accordance
with the wiring rules and the appliance must
be earthed in conformity with national electrical
safety standards.

The power cable must be long enough to connect the appliance,
once fitted in its housing, to the main power supply. Do not pull the
power supply cable.

Do not use extension leads, multiple sockets
or adapters. The electrical components must not
be accessible to the user after installation. Do not
use the appliance when you are wet or barefoot.
Do not operate this appliance if it has a damaged
power cable or plug, if it is not working properly,
or if it has been damaged or dropped.

If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard ­risk of electric shock.

If the power cable needs to be replaced,

contact an authorized service center.

WARNING: Ensure that the appliance is
switched off before replacing the lamp to avoid
the possibility of electric shock.

CLEANING AND MAINTENANCE

WARNING: Ensure that the appliance is
switched off and disconnected from the power
supply before performing any maintenance
operation; never use steam cleaning equipment ­risk of electric shock.

Do not use harsh abrasive cleaners or metal
scrapers to clean the door glass since they can
scratch the surface, which may result in shattering
of the glass.

Do not use abrasive or corrosive products,

chlorine-based cleaners or pan scourers.

Make sure the appliance has cooled down
before cleaning or performing maintenance. - risk
of burns.

WARNING: Switch off the appliance before
replacing the lamp - risk of electric shock.

To avoid damaging the electric ignition device, do not use it when

the burners are not in their housing.

DISPOSAL OF PACKAGING MATERIALS

The packaging material is 100% recyclable and is marked with the
recycle symbol . The various parts of the packaging must therefore

be disposed of responsibly and in full compliance with local authority
regulations governing waste disposal.

DISPOSAL OF HOUSEHOLD APPLIANCES

This appliance is manufactured with recyclable or reusable materials.
Dispose of it in accordance with local waste disposal regulations.
For further information on the treatment, recovery and recycling
of household electrical appliances, contact your local authority, the
collection service for household waste or the storewhere you purchased
the appliance. This appliance is marked in compliance with European
Directive 2012/19/EU, Waste Electrical and Electronic Equipment(WEEE).
By ensuring this product is disposed of correctly, you will help prevent
negative consequences for the environment and human health. The

symbol
indicates that it should not be treated as domestic waste but must be

taken to an appropriate collection centre for the recycling of electrical
and electronic equipment.

on the product or on the accompanying documentation

4

ENERGY SAVING TIPS

Only preheatthe ovenifspecified inthe cooking tableor yourrecipe. Use
dark lacquered or enamelled baking trays as they absorb heat better.

DECLARATIONS OF CONFORMITY

This appliance meets Ecodesign requirements of European Regulation
66/2014 in compliance with the European standard EN 60350-1.

This appliance meets Ecodesign requirements of European Regulation
66/2014 in compliance with the European standard EN 60350-2.

This appliance meets Ecodesign requirements of European Regulation
66/2014 in compliance with the European standard EN 30-2-1

5