IDEAL 50-682SM, 50-682SF Installation Instructions

Metal Flex - Connector

Installation Instructions:

#50-682SM

#50-682SF

Figure 2: Wires inserted through Metal Flex-Connector

Figure 3: Wires inserted into PowerPlug® Luminaire Disconnect

WARNING

Electrical Shock Hazard.

Contact with high voltage may cause falling, serious injury, or death. Disconnect power before servicing.

Electrical Fire Hazard.

Use in application exceeding voltage and current ratings listed can cause an electrical fire resulting in serious injury or death. Only use in accordance with Table 1 and local electrical wiring code.

Installation Instructions:

1. Match PowerPlug (See FIGURE 1) Pairing 30-682SM with 50-682SM and 30-682SF with 50-682SF.

2. Install anti-short bushing into flex cable.

3. Feed wiring through male metal flex-connector as shown in FIGURE 2.

4. Install wire into PowerPlug instructions for details.

5. Push PowerPlug PowerPlug

6. Insert flex cable into back end of metal flex-connector. Secure with screw to 8 in.-lbs. See FIGURE 4A and 4B.

7. Repeat steps 1-5 for female assembly (50-682SF and 30-682SF)

8. See de-mate/mate installation instructions on this page when disconnecting the connector.

Figure 1: Male & Female Sub Assemblies

FEMALE ASSEMBLY

Disconnect-Model 182S half with same gender metal flex-connector half.

Disconnect as shown in FIGURE 3. See Disconnect (Model 182S)

Disconnect into metal flex-connector until snapped into place. Make sure

Disconnect is orientated correctly. See FIGURE 1.

MALE ASSEMBLY

50-682SM50-682SF

Figure 4: Assemblies (A) Disconnected, (B) Connected

Electrical Specifications

Wiring Class Rating

Class 2 NEC/CEC Class 2 Circuit only

Not suitable for use in wet locations.

For additional specifications, reference 30-682SM and 30-682SF instruction sheet, Tables 2 and 3.

Disconnect de-mate / mate installation

1. To de-mate, rotate latch, pull metal flex-connector halves apart to separate. Do NOT pull on flex cable.

2. To mate, grasp each half, align, and push together. CLose latch to ensure full contact and secure mating.

3. Completed connection should appear as shown in FIGURE 4B.

30-682SF

30-682SM

IDEAL INDUSTRIES, INC.

Becker Place Sycamore, IL 60178, U.S.A. 800-435-0705 Customer Assistance www.idealindustries.com

ND 7608-1