Icom IC-703 Manual-Upgrad
Operation on the New 60 M Band
The new 60 M amateur band became available for use on July 3, 2003.
Operation on this band is allowed on 5 discrete frequencies and must adhere
to the following: 2.8 kHz bandwidth, USB mode, and transmit a maximum of 50
watts ERP (Effective Radiated Power).
■ Operation
It is the operator’s responsibility to set all controls so that the transmission in
the new band meets the stringent conditions under which we may use these
frequencies.
q Push [Y(BAND)] / [Z(BAND)] to select 5 MHz band.
w Push [MODE] momentarily to select USB mode.
• When LSB is selected, push for 1 sec. to select USB mode.
e Rotate the main dial to set the frequency exactly as shown is table above.
r Push [LOCK] momentarily to set the dial lock function ON, if desired.
Then operate these frequencies.
FCC Channel
Center Frequency
5.33200 MHz
5.34800 MHz
5.36800 MHz
5.37300 MHz
5.40500 MHz
A-6241H-3EX
Printed in Japan
© 2003 Icom Inc.
NOTE: We recommend
that you store these frequencies into the memory
channel for easy recall.
703 Tuning
Frequency
5.33050 MHz
5.34650 MHz
5.36650 MHz
5.37150 MHz
5.40350 MHz
[MODE]
[LOCK]
Main dial
“USB” appears
[Y]
[Z]
LSB
S1
P
O
M1 SPL A/B XFC
R
USB CW RTTY
5379
20 401060dB
5
AM WFM
VFO A
CH
Loading...