Hyundai Sonata CS-HY1120 Installation Manual
Installation Guide
NOTICE OF INTENDED INSTALLATION AND USE
THE CARSHOW MULTI-MEDIA NAVIGATION SYSTEMS CONTAIN AN INTERNAL VIDEO PLAYER, WHICH
IS NOT INTENDED FOR VIEWING BY THE DRIVER. THE VIDEO PLAYER IS DISABLED WHEN THE
VEHICLE IS IN MOTION THROUGH A CONNECTION TO THE PARKING BRAKE.
THE INSTALLER OF THIS PRODUCT MUST INSURE THE VIDEO DISABLE CONNECTION IS
WORKING PROPERLY PRIOR TO DELIVERY OF THE VEHICLE.
IMPROPER INSTALLATION COULD DISTRACT THE DRIVER OR INTERFERE WITH SAFE OPERATION
OF THE VEHICLE, WHICH COULD RESULT IN SERIOUS INJURY OR DEATH, AND COULD ALSO
VIOLATE STATE AND/ OR FEDERAL LAW.
CARSHOW DISCLAIMS ANY LIABILITY FOR ANY BODILY INJURY OR PROPERTY DAMAGE THAT MAY
RESULT FROM ANY IMPROPER OR UNINTENDED INSTALLATION AND/OR USE.
STOP
Damage to the vehicle may occur
Do not proceed until process has been completed
CAUTION
CAUTION
Process must be carefully observed in order to reduce
the risk of damage to the accessory or vehicle
CRITICAL
Process must be carefully observed in order to ensure a
quality installation
TOOLS and EQUIPMENT
Specific tools and equipment recommended for this
process
SAFETY RISK
Observe safe practices, this process can be dangerous
and there is a risk of personal injury
CS-HY1120 Hyundai Sonata Installation Guide
CarShow Copyright 2012 All Rights Reserved
Multi-Media Navigation System Installation Guide Rev A
TESTING and TROUBLESHOOTING
Content specific testing and troubleshooting points
CarShow Installation Guide
PREPARING FOR THE INSTALLATION
Before you start, please read these critical steps below
STEP
1
BEFORE YOU START THE
INSTALLATION,
READ THIS GUIDE!
CHECK THE BATTERY
Test the battery voltage to make sure it’s fully charged to
a minimum of 12.8 VDC
This only takes seconds and can save hours of
troubleshooting later.
TURN THE VEHICLE
OFF
Keep the Vehicle Off during the installation to avoid
setting various Vehicle Fault sensors
Keep the Vehicle OFF during the
installation
Failure to follow this may cause the AIRBAG FAULT
SENSOR to become enabled. Dealer Service
Departments charge a significant fee to reset the Fault
Sensor.
CarShow Copyright 2012 All Rights Reserved
Installation Guide CS-HY1124 Rev A
Page 2
CarShow Installation Guide
REMOVE THE FACTORY RADIO
You will need to remove multiple interior trim components prior to removing the factory radio.
The following steps will help guide you through this process.
STEP
2
Remove Lower Right Dash Trim
Carefully remove lower right side dash trim
Remove Lower Left Dash Trim
Carefully remove lower left side dash trim
Remove Phillips Screws
Carefully remove 2 x phillips (1-left & 1-right)screws to
release dash
CAUTION
CAUTION
Remove Radio Dash Trim
Carefully remove radio dash trim. Be sure to use proper
equipment and carefully pry on instructed area.
CarShow Copyright 2012 All Rights Reserved
Installation Guide CS-HY1124 Rev A
CAUTION
Page 3
CarShow Installation Guide
Remove Radio Dash Trim
Carefully remove radio dash trim. Be sure to use proper
equipment and carefully pry on instructed area.
Remove Radio Dash Trim
Carefully remove radio dash trim. Be sure to use proper
equipment and carefully pry on instructed area.
Remove Radio Dash Trim
CAUTION
CAUTION
Carefully remove radio dash trim. Be sure to use proper
equipment and carefully pry on instructed area.
Remove Radio Mounting Screws
Carefully remove 4 x phillips radio mounting screws
CAUTION
CarShow Copyright 2012 All Rights Reserved
Installation Guide CS-HY1124 Rev A
Page 4
CarShow Installation Guide
LOCATING REMOTE COMPONENTS
You will need to mount the GPS and Optional Satellite Radio Antennas on the exterior of the vehicle.
And mount the iPod Interface Connector in the vehicle. The following steps will help guide you
through this process.
Use Caution around SRS Components
It is the installer’s responsibility to ensure that the safety
equipment in the vehicle is NOT adversely affected by
installation of this system. Ensure that the routing of the
harnesses do NOT obstruct airbags, SRS or other safety
devices.
STEP
3
Mount the GPS and Sat Radio antenna in
a location on the exterior of the Vehicle
Route the GPS harness away from other power harnesses in
the vehicle.
This will help to ensure optimum performance of the GPS
system.
“OPTIONAL”
Install the iPod interface connector in a
location accessible to the end-user
Locate the iPod interface module in an area which can be
serviced in the future.
The iPod cable is intended to be a serviceable item, which
plugs into the iPod/Sat radio Interface Module.
INSTALL THE CARSHOW NAVIGATION SYSTEM
You will need to prepare the CarShow Navigation System for installation in the vehicle.
STEP
4
Remove the DVD Transport Screws
There are 2 x Phillips Transport Screws which protect the DVD
Mechanism during transportation.
Transport Screws must be removed prior to installation.
CarShow Copyright 2012 All Rights Reserved
Installation Guide CS-HY1124 Rev A
Page 5
Loading...