Copyright © 2010 Huawei Technologies Co., Ltd.
All Rights Reserved
No part of this document may be reproduced or transmitted in any form or by any
means without prior written consent of Huawei Technologies Co., Ltd.
Trademarks and Permissions
and other Huawei trademarks are trad emarks of Huawei T echnolo gies Co. ,
Ltd.
All other trademarks and trade names mentioned in this document are the
property of their respective holders.
Notice
The information in this document is subject to change without notice. Every effort
has been made in the preparation of this document to ensure accuracy of the
contents, but all statements, information, and recommendations in this document
do not constitute the warranty of any kind, express or implied.
Table of Contents
Getting to Know the MG323..................................................................... 1
Installing and Using an MG323 Module...................................................... 2
Removing an MG323 Module from a Development Board.............................. 4
Safety Information...........................................................错误!未定义书签。
i
Thank you for purchasing Huawei MG323 Wireless
Module.
Note:
This manual briefly describes the preparation, the process for
installing/uninstalling, and safety precautions for using Huawei MG323
Wireless Module (hereinafter referred to as the MG323).
You are recommended to read the manual before using the MG323.
The signal strength and the transmission rate are affected by the actual
environment.
Getting to Know the MG323
The following figure shows the appearance of the MG323. The actual product may
differ.
1
2
3
2
1
n Antenna interface
It is used to connect and fix an antenna.
The antenna gain:850M<4.28dBi,1900M<3.0dBi
o Fixing hole
A screw, metal fastener, and nut are used to fix an MG323 module on a
development board through this fixing hole.
p Board-to-board (B2B) connector (male)
It is connected to the B2B connector (female) on the development board.
Installing and Using an MG323 Module
1. Connect an antenna connector to the antenna interface of an MG32 3.
2