HG532t Home Gateway
1
1
Quick Start
Thank you for purchasing the HG532t Home Gateway (HG532t for short), which
compatible with both built-in antenna and external antenna appearance.
1 Adjusting the Antenna
Take the HG532t with external antenna as an example, when adjusting the antenna, refer to
the following direction.The HG532t with built-in antenna skip this operation.
2 Connecting Cables Using the ADSL Port
If there is at least one telephone jack available in your home, you can access the Internet
using digital subscriber line (DSL) services.
The connections using the HG532t with external antenna as follows:
1
1
2
3
4
5
6
7
a
c
b
1
2
3
4
5
6
7
a
c
b
The connections using the HG532t with built-in antenna as follows:
1. Power adapter 2. Desktop computer 3. Laptop computer
4. Telephone 5. Splitter Power adapter 6. Telephone wall jack
2
7. HG532t
a. Splitter MODEM port b. Splitter PHONE port c. Splitter LINE port
3 Powering On the HG532t
After you connect the cables, power on the HG532t by pressing the On/Off button on its side
panel.
After you power on the HG532t, the Power indicator lights up,the ADSL indicator lights up
and starts blinking, indicating that the ADSL port is being activated. The blinking may last
from 40 seconds to 3 minutes. When the ADSL indicator stops blinking and turns steady on, it
indicates that the cables are connected correctly and the HG532t has been activated using
ADSL.
4 Setting Network Access Parameters
Configuring a Dial-Up Connection for Internet Access
By default, the HG532t works in routing mode. The HG532t starts to set up a dial-up
connection automatically after you power it on. You do not need to install any dial-up
software or perform any dial-up operations on your computer.
To set up a dial-up connection for Internet access:
Launch a browser on your computer. Enter
Step 1
and press
Step 2
On the login page, enter your user name and password.
Step 3
Click
Step 4
Choose
Step 5
Click
Step 6
In
Step 7
User name
your service provider, and then click
Choose
Step 8
In
Step 9
SSID
Use the default settings for other parameters.and then click
.
Enter
By default, the user name is user and password is user.
For security reasons or to make the password easy to remember, you can
change the user name and password for login. For details, check the HG532t
user guide.
.
Login
>
Basic
Next
Basic
and
.
to display the WAN tab.
WAN
and
>
WLAN
WPA pre-shared key
, enter the user name and password that are provided by
Password
to display the WLAN tab.
Next
, set the wireless network name and password.
http://192.168.1.1
.
in the address box,
.
Submit
3
Loading...