Huawei B882 66 User Manual

B882-66 LTE Wireless Gateway

Quick Start

96722859_01

1 Getting to know your B882-66

Power indicator

 On: the B882-66 is powered on.
 Off: the B882-66 is powered off.

Network mode
indicator

 Blinking red: no USIM card is found, the PIN is not

verified, or the USIM card is not working properly.

 Steady cyan: registered with an LTE network.
 Steady blue: registered with a 3G network.
 Off: no signal.

Wi-Fi/WPS
indicator

 Steady on: Wi-Fi turned on or data transfer in

progress.

 Blinking: a WPS connection is being set up.
 Off: Wi-Fi turned off.

SMS indicator

 Steady on: inbox is full.
 Blinking: new messages.

Call status
indicator

 Steady on: call in progress.
 Blinking: incoming call.

3

Wireless
connection
indicator

 Steady on: connected to a LTE/3G network.
 Blinking: connecting to a LTE/3G network.

/ /

LAN indicator

 Steady on: LAN port is connected to a client.
 Blinking: data is being transmitted through LAN

port.

 Off: no client is connected to LAN port.

Wired
connection
indicator

 Steady on: connected to an Ethernet network.
 Blinking: connecting to an Ethernet network.

USIM card slot

Install a USIM card to access to the Internet via a
LTE/3G data connection.

Dial-up button

The B882-66 can access the Internet in Auto, Manual,

or On Demand mode.

In Manual mode, press it to manually connect to or
disconnect from the Internet.

Wi-Fi/WPS
button

 Press and hold for about 3 seconds to turn on or off

Wi-Fi.

 Press and hold for 6 or more seconds to active

WPS connection when Wi-Fi is turned on.

Reset button

Restoring the default settings of the B882-66 will

erase all previous sett ings.

When the B882-66 is powered on, use a sharply
pointed object to press and hold for about 3 seconds
until all indicators are blinking to restore the B882-66
to its factory settings. After the factory defaults are
restored, the B882-66 will restart automatically.

WAN port

Connect to an Ethernet port on the wall through a
network cable if you want to access to the Internet via
wired way.

/ /

LAN port

Connect to computer, switch, or other LAN device.

4

Telephone port

Connect to telephone.
Power port

Connect to compatible power adapter.
Power button

Press and hold for about 3 seconds to power the
B882-66 on or off.

5

2 Installation

Before install ing or removing the USIM card, ensure that the B882-66 is powered off
and disconnected from the power outlet.

Installing the USIM card

If you want to use LTE/3G wireless data service and voice service, please install the
USIM card.

1. Pull out the card slot cover and rotate it to reveal the USIM card slot.

2. Partially insert the USIM card into the card slot. Ensure that the beveled edge of the

USIM card aligns with that of the card slot. Gently push the card until it clicks into
place.

3. Close the card slot cover.

6