HOOVER HGH 640 1 B, HGH 640 1 SW, HGH 640 1 SB, HGH 640 1 SX, HGH 640 1 W User Manual

HOBS
USER INSTRUCTIONS

Grafica RB - 09-2005 - Cod. 41017810 - Imprimè en Italie

HOOVER - Via Privata Eden Fumagalli - 20047 Brugherio (Milano) - Italy

GB IE

2

INSTRUCTIONS FOR THE INSTALLER

INSTALLATION

The Purchaser is responsible for the installation of the hob. The Manufacturer does not
accept any responsibility for any damage or loss resulting from incorrect installation,
and as such this will not covered by the Manufacturer’s Guarantee.
The hob may be installed in any worktop which is heat resistant to a temperature of
100° C, and has a thickness of 25 - 45 mm. The dimensions of the insert to be cut out
of the worktop are in shown in Fig. 1.
If the Hob is fitted next to a cabinet on either side, the distance between the Hob and the
cabinet must be at least 15 cm (see Fig. 2); while the distance between the hob and the
rear wall must be at least 5,5 cm.
The distance between the hob and any
other unit or appliance above it (e.g. An ex­tractor hood) must be no less than 70 cm
(fig.2).
When there is an accessible space between
the built-in hob and the cavity below, a divi­ding wall made of insulating material should
be inserted (wood or a similar material)

(fig.

3).

Important - The diagram below shows
how the sealant should be applied.

The Hob unit is fitted by attaching the Fixing
Clamps supplied, using the holes at the base of the unit.

Fig. 1

Fig. 2

Fig. 3

accessible space

GB IE

Plan 60 Plan 75

4 a gas 5 a gas

- / si - / si

si si

PL 03/PL 04

PL 73/PL 74

11

11
11

8,75 kW

11,25 kW

636 g/h 818 g/h

220-240/50 220-240/50

BUILT IN HOBS

Burners/hotplates

Type / reference
Flame failure device
Little burner AUS ø 50 mm
Double ring burner QC ø 135 mm
Ultra rapid burner UR ø 110 mm
Semirapid burner SR ø 75 mm
Rapid burner R ø 100 mm
Griddle 174x160 mm
Griddle 229x379
Electric plate ø80 PE
Electric plate ø145 PE
Electric plate 160x265 mm PE
Installed gas Type/Power:
G20 20mbar* (METHANE)
G30 28-30mbar (GPL)
Installation class
Voltage/Frequency V/Hz
Electrical imput power
Electronic ignition

Product dimension WXD (mm)

1

* Manufacturer setting IE cat. II2H3 + GB cat. II2H3 +

Tab. 1

This appliance has been designed for non-professional, i.e. domestic, use.

GB IE