Honeywell TR40, TR42 Operation Manual

Zio® Lite

TOOL CONFIGURATION, NETWORK ACCESS,
SYLK™ CAPACITY, AND OPERATION
TR40/TR42

Contents

Tool Configuration ............................................................ 1

General Settings Tab (Fig. 1). .................................... 2

Categories and Parameters Tab (Fig. 4). ................... 5

Home Screen Options Tab (Fig. 6). ............................ 8

Occupancy and Override Tab (Fig. 7) ........................ 9

Fan Command Tab (Fig. 8) ........................................ 10

Password Tab (Fig. 9) ................................................. 11

Network access to Zio Lite fields ...................................... 12

Sylk Capacity .................................................................... 13

Operation .......................................................................... 14

TR42 Wall Module Keypad Contractor Configuration . 14

Tenant Operation of Zio Lite TR42 ............................. 15

TOOL CONFIGURATION

OPERATING GUIDE

The Zio Lite is configured using the same SBusWallModule wiresheet block as the Zio and Zio Plus, which is located in the BuiltIn
folder in the HoneywellSpyderTool palette. The configuration wizard has been modified to include the new TR40/42 Zio Lite
models.

Because the Zio Lite functionality is a subset of the Zio, it is fairly easy to set up.

Add the SBusWallModule block to the wire sheet, right click on the block, and select Configure Properties to enter the
configuration wizard.

63-2741-01

ZIO® LITE

General Settings Tab (Fig. 1).

Fig. 1. General Settings Tab.

Change the name in Block Name if desired, and then choose the TR40/42 you plan to configure (Fig. 1).

63-2741—01 2

If you choose a TR40 type, you will have just the general settings tab to set up (Fig. 2).

ZIO® LITE

Fig. 2. General Settings tab.

Choose the wall module address. This address must match the bus address on the wall module, which is configured using the dip
switches on the back of the device.

Enter the F/C wiresheet units (required on TR4X models) and any offset to the sensor values if desired.

Click Finish, and you are done with configuration.

3 63-2741—01

ZIO® LITE

For TR42 models (Fig. 3), you can also select International to reduce the amount of English in the tenant view if you plan to have
many non-English speakers using the device. You can also choose to make Language an editable option for the tenant by
checking the box.

Contractor set up at the wall module remains in English with either selection.

Fig. 3. General Settings tab.

63-2741—01 4

Categories and Parameters Tab (Fig. 4).

ZIO® LITE

Fig. 4. Categories and Parameters tab.

Unlike the Zio, the Zio Lite has just two fixed categories (Sensors and Setpoint), and just a few parameters for the supported
sensors and the temperature setpoint. It is not possible to create new categories or parameters.

For ROOMTEMP, select the number of decimals you wish to show and then check the Viewable by Tenant box if you want the
tenant to see this value in the MORE screen on the thermostat. Enter a default offset value if desired. Repeat these steps for
HUMIDITY.

If you choose not to View any values, then there will be no access to the MORE screen. “MORE” will not show up in the display,
and that softkey will be inactive. See “About the MORE screen” further down.

The F/C units shown in the display for measured room temperature will be the units chosen for the Tempstpt (Temperature
Setpoint).

5 63-2741—01