Honeywell Silent Knight IDP-Monitor-2 Installation And Maintenance Instructions Manual
0
1
2
3
4
9
8
7
6
5
0
TENS
O
NES
ADDRESS
LOOP
9
8
7
6
5
4
3
2
1
0
9
8
7
6
5
4
3
2
1
INSTALLATION AND MAINTENANCE
9
8
7
6
5
4
3
2
1
0
0
1
2
3
4
5
6
7
8
9
TENS
ONES
ADDRESS
LOOP
1
0
7
8
6
5
4
3
2
9
0
1
2
3
4
8
7
6
5
9
O
N
E
S
A
D
D
R
E
S
S
TE
N
S
1
0
2
3
4
5
6
7
8
9
1
0
2
3
4
5
6
7
8
9
INSTRUCTIONS
IDP-Monitor-2
Dual Monitor Module
Specifications
Normal Operating Voltage: 15 to 32 VDC
Maximum Current Draw: 5.7 mA (LED on)
Average Operating Current: 750µA (LED flashing)
EOL Resistance: 47K Ohms
Max. IDC wiring resistance: 1,500 Ohms
Temperature Range: 32˚F to 120˚F (0˚C to 49˚C)
Humidity: 10% to 93% Non-condensing
Dimensions: 41/2˝ H x 4˝ W x 11/4˝ D
(Mounts to a 4˝ square by
21/8˝ deep box.)
Accessories: SMB500 Electrical Box
Mounting
Mounts directly to 4˝ square electrical boxes (see Figure
2A). The box must have a minimum depth of 21/8˝.
Surface mounted electrical boxes (SMB500) are available
from Silent Knight.
Wiring
NOTE: All wiring must conform to applicable local
codes, ordinances, and regulations. This module is intended for power limited wiring only.
1. Install module wiring in accordance with the job draw
ings and appropriate wiring diagrams.
2. Set the address on the module per job drawings.
Note: Monitor module L (using terminals 6 and 7) re
sponds at the address set on the code switches. Monitor
module H (using terminals 8 and 9) will automatically
respond at the next higher address. For example, if the
code switches are set to 76, module L will respond at
address 76 and module H will respond at address 77.
Use caution to avoid duplicate addressing of modules
on the system.
3. Secure module to electrical box (supplied by installer),
as shown in Figure 2A.
Figure 1. Controls and Indicators:
-
-
Before Installing
This information is included as a quick reference installation guide. Refer to the control panel installation manual for detailed system information. If the modules will
Figure 2A.
Module mounting:
be installed in an existing operational system, inform the
operator and local authority that the system will be temporarily out of service. Disconnect power to the control
panel before installing the modules.
NOTICE: This manual should be left with the owner/
user of this equipment.
C0218-01
General Description
The Dual Monitor Module is intended for use in intelligent, two wire systems. It provides two independent
2-wire initiating device circuits (IDC), at two separate,
consecutive addresses. It is capable of monitoring normally open contact fire alarm and supervisory devices, or
either normally open or normally closed security devices.
The module has a single panel controlled red LED.
Compatibility Requirements
To ensure proper operation, this module shall be connected to a compatible Silent Knight system control panel
(list available from Silent Knight).
C0156-00
K200-13-00 1 I56-2730-002
Figure 2B:
C0157-00
0
7
8
6
5
4
3
2
1
9
FROM
PA
NEL
OR
(+)
(–)
TO
NEXT
(+)
(–)
DEVICE
(+)
(–)
MONIT
OR
CONNEC
T
MODULE
S
TO
LISTED COMP
AT
IBLE
32 VDC MAX.
SHIELDED-TWIST
ED P
AIR
IS RECOMMENDED
SILEN
T
KNIGHT
CON
T
ROL
P
ANELS ON
LY
PREVIOUS DEVICE
SIGNAL
L
INE CIRCUIT
(SLC)
MONIT
OR
A
(
TERMINALS 6 & 7) RESPONDS
AT
ADDRESS
SET
ON CODE SWIT
CHES. MONIT
OR B (T
ERMINALS 8 &
9)
RESPONDS
A
T
NEXT
HIGHER
ADDRESS.
ANY
NUMBER OF UL
LISTED CONT
ACT
CLOSURE
DEVICES MA
Y
BE USED. DO NOT
MIX FIRE
ALARM INITIA
TING, SUPER
VISOR
Y
, OR SECURITY
DEVICES ON
THE SAME INITI
A
TING DEVICE CI
RCUIT
.
INST
ALL
CONT
ACT
CLOSURE DEVICES PER
MANUF
ACTURER'S INST
ALLA
TION INSTRUCTI
ONS.
47 K EOL
RESIST
OR
ELR-47K
MODULE
47 K EOL
RESIST
OR
ELR-47K
H
L
9
8
7
6
5
4
3
2
1
0
TENS
ONES
ADDRESS
LOOP
0
2
4
6
8
TWO INITIA
TING DEVICE CIRCUITS (L
& H),
EACH POWER LIMITED
TO
230
A
@ 12VDC MAX.
ALL
WIRING
SHOWN IS
SUPER
VISED
AND POWER LIMITE
D
Figure 3. Typical 2-wire initiating circuit configuration, NFPA Style B:
C0809-01
K200-13-00 2 I56-2730-002
7550 Meridian Circle
Maple Grove, MN 55369-4927
763-493-6455; 800-328-0103
Fax: 763-493-6475
http://www.silentknight.com
© 2006 Silent Knight 2/06
Loading...