Honeywell Hcm525 Owner's Manual

NATURAL COOL
MOISTURE

TM

HUMIDIFIER

HCM-525 Series

IMPORTANT
SAFETY
INSTRUCTIONS

READ AND SAVE THESE
SAFETY INSTRUCTIONS
BEFORE USING THIS HUMIDI­FIER

When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the fol­lowing:

1. Always place this humidifier on a firm, flat and level
surface. This humidifier may not work properly on an
uneven surface.

2. Place this humidifier in an area where it is not acces­sible to children.

3. Do not place the humidifier near any heat sources
such as stoves, radiators, and heaters.

4. Before using the humidifier, check the power cord for
any signs of damage. If the cord is found to be dam­aged, DO NOT USE and return the humidifier to the
manufacturer under the warranty agreement for
repair.

5. This appliance has a polarized plug (one blade is
wider than the other). To reduce the risk of shock,
this plug is intended to fit only one way in a polarized
outlet. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a quali-

fied electrician. DO NOT attempt to defeat this safety
feature.

6. To disconnect the humidifier, first turn controls to the

OFF position, then grip the plug and pull it from the
wall outlet. Never pull by the cord.

7. A loose fit between the AC outlet (receptacle) and
plug may cause overheating and a distortion of the
plug. Contact a qualified electrician to replace loose
or worn outlet.

8. The humidifier should always be unplugged and emp­tied when not in operation or while being serviced or
cleaned.

9. Never tilt or attempt to move the humidifier while it is
operating or filled with water. UNPLUG the humidifier
before moving.

10. This humidifier requires regular cleaning. Refer to
the CLEANING instructions provided. Never clean
the humidifier in any manner other than as instructed
in this manual.

11. Turn the humidifier OFF if you notice moisture on
the inside of your windows. For proper humidity read­ing use a hygrometer, which is available in many
hardware and department stores, or by ordering one
from the manufacturer (see Care Products).

1

WHAT IS AGION ANTIMICROBIAL?

AgION* technology prevents surface growth and
migration of mold, fungus and bacteria in the filter
for its life - approximately one season. Keep in
mind, depending on your water quality, mineral
deposits can still clog or discolor the filter and
affect its life and that of the humidifier.

* AgION is registered with the Environmental Protection Agenc y (EPA)

YOUR HUMIDIFIER:

Tank

Natural Cool

TM

Moisture
Filters

Removable

Water Tray

PO

W

E
R

Motor Housing

SET-UP:

wet Filters back into the Removable Tray. DO
NOT squeeze or wring-out the Filters.

Honeywell will not accept responsibility for prop­erty damage caused by water spillage.

FILLING:

• Remove the Tank from the Removable Tray.

• Turn the Tank over and unscrew the Cap.

• Fill the Tank with cool water.

• Reinstall the Cap. Do not overtighten.

• Install the Tank back onto the Removable Tray.

OPERATION:

Humidistat Knob

• Ensure the humidifier is OFF prior to plugging it into a

polarized 120 volt AC outlet.

• Turn the Humidistat Knob to

• Set the Output Control Knob to the desired output
level.

• When the room has reached a comfortable humidity
level, turn the Humidistat Knob slowly counter-clock­wise until the fan stops. The
light will be illuminated.

• The humidistat will automatically restart the humidifier
when the humidity level in the room falls below this
moisture setting. This on/off cycle will continue while
the humidifier is in use.

• Lower the humidity level if condensation forms on
walls or windows.

Output Control

Knob

HIGH.

DESIRED HUMIDITY

Note: We recommend that the humidifier be
disinfected prior to first use. Please see
WEEKLY CLEANING instructions.

• Select a firm, level and flat location. For proper
air flow, locate the unit at least six inches (15
cm) from any wall. Place the humidifier on a
water resistant surface, as water can damage
furniture and some flooring.

TM

• Remove the Natural Cool Moisture

Filters
from the Removable Tray before filling the unit.
Soak the Filters in cool water and then place the

2