Honeywell Hcm2000c, Hcm1010, Hcm3000, Hcm3040, Hcm2050 Owner's Manual
...
OWNER’S MANUAL
4 GALLON OUTPUT PER DAY
COOL MOISTURE HUMIDIFIER
Model HCM-2051 Series
* Output dependent on room temperature and humidity.
IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE THESE SAFETY INSTRUCTIONS
BEFORE USING THIS HUMIDIFIER
When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons,
including the following:
1. Always place this humidifier on a firm, flat and level surface. This humidifier may not work
properly on an uneven surface.
2. Place this humidifier in an area where it is not accessible to children.
3. Do not place the humidifier near any heat sources such as stoves, radiators, and heaters.
4. Before using the humidifier, check the power cord for any signs of damage. If the cord is
found to be damaged,
the warranty agreement for repair.
5. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk
of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
DO NOT attempt to defeat this safety feature.
6. To disconnect the humidifier, first turn controls to the OFF position, then grip the plug and
pull it from the wall outlet. Never pull by the cord.
DO NOT USE and return the humidifier to the manufacturer under
7. A loose fit between the AC outlet (receptacle) and plug may cause overheating and a
distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.
8. The humidifier should always be unplugged and emptied when not in operation or while
being serviced or cleaned.
9. Never tilt or attempt to move the humidifier while it is operating or filled with water.
UNPLUG the humidifier before moving.
10. This humidifier requires regular cleaning. Refer to the CLEANING instructions provided.
Never clean the humidifier in any manner other than as instructed in this manual.
11. Turn the humidifier OFF if the relative humidity exceeds 60%, or if you notice moisture on
the inside of your windows. For proper humidity reading use a hygrometer.
INTRODUCTION
Thank you for purchasing a Honeywell Natural Cool Moisture®Humidifier. If you would like
more information on our full line of products please visit our website at:
www.honeywell.com/yourhome.
HOW DOES IT WORK?
NATURAL COOL MOISTURE®SYSTEM
Dry air is pulled through the Natural Cool Moisture®system and a quiet fan blows out
invisible, moisture-balanced air. Unwanted minerals and bacteria from the water are trapped
inside the Natural Cool Moisture
“mist”. You will know your humidifier is putting moisture into the air as you watch the water
level in your tank decrease throughout the day.
®
filter. When the unit is running you will not see or feel a
WHAT IS AgION
™ ANTIMICROBIAL
?
Your Honeywell Natural Cool Moisture®filter has been designed using new AgION™
technology which prevents surface growth and migration of mold, fungus, algae and bacteria
in the filter for its life - approximately one season. Keep in mind, depending on your water
quality, mineral deposits can still clog or discolor the filter, affect its life and that of the
humidifier.
MODEL - HCM-2051
Your humidifier is made up of these parts:
Water Tank
Motor Housing
Natural Cool
Moisture
®
Filter
Fill Cap
Base
SET UP
NOTE: We recommend that the humidifier be disinfected prior to first use. Please
see CLEANING instructions.
• Select a firm, level, flat location - at least six inches from any wall for proper air flow (Fig.
1). Place the humidifier on a water-resistant surface, as water can damage furniture and
some flooring.
The manufacturer will not accept responsibility for property damage caused by water
spillage
FILLING
• Remove the water tank by grasping handle and
pulling straight up (Fig. 1). Set aside.
• Lift up on the motor housing to remove and set aside
(Fig. 2). Remove the Natural Cool Moisture
®
filter
from the base before filling the unit with water. Soak
filter in a sink full of cool water to help reduce
mineral build up and place back in the humidifier
while wet. DO NOT SQUEEZE OR WRING OUT THE
NATURAL COOL MOISTURE
®
FILTER. To help extend
the life of your filter repeat this step each time you
fill your humidifier.
• Turn the Water Tank upside down so that the Fill Cap
is facing up; unscrew the Fill Cap by turning it
counter-clockwise and set aside.
Fill the Water Tank with COOL tap water (Fig. 3).
•
Distilled water is not necessary as the water is filtered
by the Natural Cool Moisture
WATER.
Doing so may damage the humidifier.
®
filter.
DO NOT USE HOT
• Replace the fill cap by turning it clockwise . DO
NOT OVER TIGHTEN. Turn the Water Tank right-side
up.
NOTE: WHEN CARRYING THE FILLED WATER TANK
PLEASE USE THE HANDLE AND PLACE YOUR OTHER
HAND UNDER THE TANK FOR ADDITIONAL SUPPORT.
Fig. 1
WALL
6"
Fig. 2
Fig. 3
Loading...