Honeywell 301EM-20, 301EM Quick Start Guide

Find out more

www.honeywellanalytics.com

To ll free: 1 800 563 2967

Please Note:

While every effort has been made to ensure accuracy in this publication, no responsibility can be accepted for errors or omissions. Data may change, as well as legislation, and you are strongly advised to obtain copies of the most recently issued regulations, standards, and guidelines. This publication is not intended to form the basis of a contract.

301EM-20 SPECIFICATIONS

Controller

General Specification

Use

Power Requirement

Size

Weight

Distance Between Controller and Sensor

Visual Indicators

Alarm Levels

Outputs

Relay Output Rating

Gases Detected

301IRFS

Wall mounted mechanical room controller for use with Honeywell Analytics 301IRFS and S301D2 gas sensors for up to 20 points of detection. Four (4) onboard relays can be used to activate alarms or deactivate equipment.

22-27 VAC, 29-38 VDC, 2A max @ 29VDC

11 (H) x 8 (W) x 2.7 (D) in. (28 x 20.3 x 7 cm)

2.25 lbs. (1.02 kg)

301IRFS refrigerant sensors: Up to 200 ft. (60.9 m) S301D2 toxic/combustible sensors: Up to 500 ft. (160 m)

Normal Operation Green LED

Alarm Level 1 Red LED

Alarm Level 2 Red LED

Alarm Level 3 Red LED

Signal Tx Blinking amber LED

Failure Indication Yellow LED

3 with high and low setpoints

4 DPDT relays (alarms and/or fault), buzzer

Three 24 VDC, 250mA (per output)

Four 4-20mA outputs

Modbus

RFS option: 24 VDC built-in red strobe

RFSA option: 24 VDC built-in red strobe & 105 dBA horn

5 A, 30 VDC or 250 VAC (resistive load)

Gases Detected Detection Range Operating Temperature Operating Humidity Range

R11, R22, R123, R125, R134A, R404A, R407C, R410A, R507A

S301D2

Carbon Monoxide (CO) 0-250 ppm -40° to 100°F (-40° to 40°C) 0-95% non-condensing

Chlorine (Cl

Nitrogen Dioxide (NO2) 0-10 ppm -40° to 100°F (-40° to 40°C) 0-95% non-condensing

Hydrogen Sulfide (H2S) 0-50 ppm -40° to 100°F (-40° to 40°C) 0-95% non-condensing

Sulfur Dioxide (SO2) 0-10 ppm -40° to 100°F (-40° to 40°C) 0-95% non-condensing

Oxygen (O2) 0-25% -4° to 104°F (-20° to 40°C) 0-95% non-condensing

Combustibles 0-100% LEL -40° to 112°F (-40° to 50°C) 0-95% non-condensing

Ratings and Certification

Alarm Levels

Conforms to

CAN/CSA C22.2 No. 61010-1

116662

ANSI/UL 61010-1

) 0-15 ppm -40° to 100°F (-40° to 40°C) 0-95% non-condensing

0-1,000 ppm 32° to 104°F (0° to 40 °C) 0-95% non-condensing