301C SPECIFICATIONS
Controller
General Specification
Use
Power Requirement
Size
Weight
Network Capacity
Digital Communication
Communication Line
Lengths
Relay Output
Alarm Levels
Time Delays
Outputs
Events
Display
Operating Humidity Range
Operating Temperature
Range
Security
Zoning
Optional Memory
Ratings and Certification
Certified to
Certified by
Designed to comply with
Controller for centralized gas detection monitoring with real-time gas reading, selective alarm activation
and low cost installation
17-27 VAC, 24-38 VDC, 500mA
11 (W) x 8 (H) x 2.8 (D) in. (28 x 20.3 x 7 cm)
2.4 lbs. (1.1 kg)
Three RS-485 channels for up to 96 transmitter inputs
Optional BACnet/IP interface, BTL listed as a smart sensor
Up to 2,000 ft. (609 m) per channel
T-Tap: 65 ft. (20 m), maximum per T-Tap
130 ft. (40 m), maximum for all T-Tap combined
5 A, 30 VDC or 250 VAC (resistive load)
Four fully programmable alarm levels
0, 30 sec, 45 sec, 1-99 minutes before and after alarm
4 DPDT relays (alarms and/or fault); 65dBA buzzer
Flexible programming that can include: alarms, gas concentrations, faults, real time clock, voting, optional outlier detection,
and time since calibration
Large 122 x 32 dot matrix display
0 to 95% RH (non-condensing)
-4° to 122°F (-20° to 50°C)
Password protection for tamper resistance
Up to 126 programmable zones
2GB removable SD Card for configuration, readings, and events
For USA: Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory Use - Part 1: General
Requirements (ANSI/UL 61010-1, 2nd Edition, Dated July 12, 2004 Including Revisions Through October 28, 2008)
For Canada: Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory Use - Part 1: General
Requirements (CAN/CSA C22.2 No. 61010-1:04, 2nd Edition, Dated July 12, 2004 Including General Instruction 1 – October
2008 (Reaffirmed 2009))
Intertek
IEC 61010-1:2010 (Third Edition)
California Title 24, Part 6, and associated administrative regulations In Part 1
Find out more
www.honeywellanalytics.com
Toll free: 1 800 563 2967
Please Note:
While every effort has been made to ensure accuracy in this publication, no responsibility can be accepted for errors or omissions.
Data may change, as well as legislation, and you are strongly advised to obtain copies of the most recently issued regulations,
standards, and guidelines. This publication is not intended to form the basis of a contract.
SS01005_v3 7/15
© 2015 Honeywell Analytics