HONDA Automobile Accessories User Manual
INSTALLATION
www.collegehillshonda.com/parts
INSTRUCTIONS
Accessory Application Publications No.
KEYLESS ENTRY
2001 ACCORD (LX)
2- AND 4-DOOR
(INCLUDES V6)
AII 21619
Issue Date
AUG 2000
PARTS LIST
Keyless Entry Attachment (sold separately):
P/N 08E65-S84-100
Keyless entry wire
harness
Sub-harness
Control unit bracket
Wire tie with clip
8 Long wire ties
Connector clip
Relay, 4-pin
2 Relay brackets
3 Short wire ties
3 Washer-bolts, 6 x 12 mm
Ground bolt
3 Flange nuts, 6 mm
3 Self-tapping screws
Relay, 5-pin
Fuse labels
© 2000 American Honda Motor Co., Inc - All Rights Reserved. AII 21619 (0008) 1 of 10
Y0581-A 08E65-S84-1000-91
Keyless Entry System (sold separately):
P/N 08E61-S84-100
2 Transmitters
Control unit
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your car. These procedures should
not be attempted by "do-it-yourselfers."
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
Owner’s Manual
2 Washer-screws, 4 x 30 mm
TOOLS AND SUPPLIES REQUIRED
Small flat-tip screwdriver
#2 Phillips screwdriver
Tape measure
File
Felt-tip pen
Pliers
17 mm Combination wrench
10 mm Socket wrench
Ratchet
Utility knife
Illustration of the Keyless Entry Installed on the
Vehicle
4-PIN
RELAY
RIGHT
FUSE BOX
6-PIN RELAY
2. Disconnect the negative cable from the battery.
3. Inside the passenger compartment, remove the
front console lower cover (four retaining clips).
FRONT
CONSOLE
LOWER COVER
CLIP
LEFT
FUSE
BOX
KEYLESS
ENTRY WIRE
HARNESS
CONTROL UNIT
2 of 10 AII 21619 (0008) © 2000 American Honda Motor Co., Inc - All Rights Reserved.
If the vehicle you’re working on is equipped with an
optional ashtray with cigarette lighter, continue with
step 4; if not, go to step 5.
6. Remove the driver's dashboard lower cover
(three screws and five retaining clips).
4. Remove the ashtray with cigarette lighter (two selftapping screws, one connector, and four retaining
clips).
ASHTRAY WITH
CIGARETTE
LIGHTER
CONNECTOR
SELF-TAPPING
SCREWS
CLIP
SCREW
SCREW
DRIVER'S
DASHBOARD
LOWER COVER
CLIP
SCREW
7. Remove the driver's door sill molding (four clips).
5. Remove the left fuse box cover (three clips and
two tabs).
TAB
CLIP
LEFT FUSE
BOX COVER
TAB
LEFT
FUSE BOX
CLIP
DRIVER'S
DOOR SILL
MOLDING
CLIP
© 2000 American Honda Motor Co., Inc - All Rights Reserved. AII 21619 (0008) 3 of 10
Loading...