Distributed by
®
Shiatsu Massage Chair
Traveling Shiatsu Mechanism
|
|
|
|
ke A Mo |
m |
|
|
|
|
|
a |
|
|
||
|
|
T |
|
e |
|
||
|
|
e |
|
|
|
n |
|
|
|
|
|
|
t |
||
|
|
s |
|
|
|
|
N |
|
a |
|
|
|
|
o |
|
le |
Register |
w |
|||||
P |
|
|
|
|
|
|
|
Your Product At: www.homedics.com/register
Your valuable input regarding this product will help us create
the products you will want in the future.
Instruction Manual and
Warranty Information
OCTS-200
El manual en€español empieza a la página 16
®
IMPORTANT SAFEGUARDS
WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
DANGER- TO REDUCE THE RISK OF ELECTRIC SHOCK:
•ALWAYS unplug the appliance from the electrical outlet immediately after using and before cleaning.
•DO NOT reach for an appliance that has fallen into water. Unplug it immediately.
•DO NOT use while bathing or showering.
WARNING - TO REDUCE THE RISK OF BURNS, ELECTRIC SHOCK, FIRE OR INJURY TO PERSONS:
•An appliance should never be left unattended when plugged in. Unplug from outlet when not in use and before putting on or taking off parts or attachments.
•Close supervision is necessary when this appliance is used by, on or near children, invalids or disabled persons.
•Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by HoMedics; specifically any attachments not provided with the unit.
•NEVER operate this appliance if it has a damaged cord or plug, if it is not working properly, if€it€has been dropped or damaged, or dropped into water. Return it to HoMedics Service
Center for examination and repair.
•Keep cord away from heated surfaces.
•NEVER use while sleeping or fall asleep while using the massager.
•NEVER drop or insert any object into any opening.
•DO NOT operate where aerosol (spray) products are being used or
where oxygen is being administered.
• DO NOT operate under a blanket or pillow. Excessive heating can occur and cause fire, electrocution or injury to persons.
• DO NOT carry this appliance by supply cord or use cord as handle.
•To disconnect, turn all controls to the “OFF” position, then remove plug from outlet.
•Never operate the appliance with the air openings blocked. Keep the air openings free of lint, hair, and the like.
•Use heated surfaces carefully. May cause serious burns. Do not use over insensitive skin areas or in the presence of poor circulation.
The unattended use of heat by children or incapacitated persons may be dangerous.
•Do not use outdoors.
SAVE THESE INSTRUCTIONS
Caution — Please read all instructions carefully before operating.
•This product is not intended for medical use. It is intended only to provide a luxurious massage.
•Consult your doctor prior to using this product, if
-You are pregnant
-You have a pacemaker
-You have any concerns regarding your health
•Not recommended for use by diabetics.
•NEVER leave the appliance unattended, especially if children are present.
•NEVER cover the appliance when it is in operation.
•DO NOT use this product for more than 15 minutes at a time.
•Extensive use could lead to the products excessive heating and shorter life. Should this occur, discontinue use and allow the unit to cool before operating.
•NEVER use this product directly on swollen or inflamed areas or skin eruptions.
•DO NOT use this product as a substitute for medical attention.
•DO NOT use this product before bed. The massage has a stimulating effect and can delay sleep.
•This product should NEVER be used by any individual suffering from any physical ailment that would limit the user’s capacity to operate the controls.
•This product should never be used by any individual suffering from any ailments that would limit or altogether inhibit the user’s capacity to feel or have any sensation in the body part that the product is being used on.
•This unit should not be used by children or invalids without adult supervision.
Instructions for Use
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
2 |
3 |
Assembly Instructions
INVENTORY OF PARTS: |
|
A. Seat Back (x1) |
G. Seat Base Mechansim (x1) |
B. 6mm Allen Wrench (x1) |
H. Plastic Cone Cover (x1) |
C. Armrests (x2) |
I. Star Base (x1) |
D. Screw Covers (x8) |
J. Rolling Castors (x5) |
E. 8m x 25mm Screws (x12) |
K. Pneumatic Cylinder (x1) |
F. Seat Cushion (x1) |
|
Figure 1
Instructions
1.Place the star base face down and firmly press the rolling castors into place.
Figure 2A
Figure 2B
2.Insert the pneumatic cylinder into the star base and cover with the plastic cone cover.
Figure 3
4 |
5 |
3. Attach the seat base mechanism to the underside of the seat cushion using the included Allen wrench and 4 of the screws. Make sure the arrow on the seat base mechanism is pointing toward the front edge of the seat cushion (label on seat cushion).
5. Attach the armrests (labeled as R and L for right and left sides) onto the seat cushion using the included Allen wrench and 4 of the screws (2 on each side). DO NOT TIGHTEN THE SCREWS COMPLETELY.
Figure 4
4.Place the seat cushion on top of the pneumatic cylinder. Make sure the cylinder is positioned properly by sitting on the seat cushion.
Figure 6
6.Connect remote arm wires to chair wires and feed into the opening in the side of the chair.
Figure 7A |
Figure 7B |
Figure 5
6 |
7 |
7. Attach the seat back onto the armrests so it is properly aligned with the seat cushion using the included Allen wrench and the remaining
4 screws (2 on each side).
Note: Heat only works with massage function activated
Figure 8
8.Once the armrests are properly aligned with both the seat cushion and seat back, completely tighten all 8 screws (4 on each side) and cover with provided screw covers.
Massage Cushion and
Hand Control Instructions
Power On/Off
To turn the massage function on, press the power button. The corresponding LED will illuminate to indicate power on. To turn the massage function off, press the power button again. As the chair is powering off, the power button LED will flash and the mechanism will automatically move to the bottom of the chair where it will “park” for the next use. No other buttons or functions will be available during the parking. Once the mechanism has parked, the power LED will turn off.
Shiatsu Programs
Once the chair is powered on, you can select a massage program.
Upper Back: Press the button labeled “Upper Back” to select the massage program for that area. The corresponding LED will illuminate to indicate that program is engaged. To end the upper back program, press the button a second time. The LED will turn off.
Lower Back: Press the button labeled “Lower Back” to select the massage program for that area. The corresponding LED will illuminate to indicate that program is engaged. To end the lower back program, press the button a second time. The LED will turn off.
Full Back: Press the button labeled “Full Back” to select the massage program for that area. The corresponding LED will illuminate to indicate that program is engaged. To end the full back program, press the button a second time. The
LED will turn off.
Heat
To use heat during any massage program, press the “Heat” button.
The corresponding LED will illuminate to indicate that the heat function is on. To end the heat function, press the heat button a second time. The LED will turn off. Please note that the heat function CANNOT be used without the massage function.
Demo
To cycle through all the massage programs and heat, press the “Demo” button. The corresponding LED will be flashing to indicate the demo mode is functioning. Please note that if no other massage program is selected, the massage mechanism will park at the end of the demo cycle.
8 |
9 |
Massage Program Buttons
Direct massage to specific areas: lower back, upper back or full back. Press the button for your desired program and the corresponding L.E.D. will illuminate. To deselect an area(s), simply push the button again and the corresponding L.E.D. light will turn off.
Power Button
To turn on the massage functions, first€press the power button. The L.E.D. indicator will illuminate and confirm your selection. The massage functions can then be activated by pressing the appropriate buttons. To turn off the massage functions, simply press the button again and the L.E.D. indicator will turn off.
Shiatsu Massage Chair
Traveling Shiatsu Mechanism
Demo Button
For a brief demonstration of the features of the
Traveling Shiatsu Office Chair, press the demo button. The unit will complete one cycle of each massage style. Once complete, the unit automatically turns itself off.
Heat
Soothing heat is activated with this button. To activate the heat, first turn on the massage function. The L.E.D. light will glow to indicate the heat is on. To turn off heat, simply press the button again.
Note:
As with all high-quality massage products, there is a 15-minute auto shut-off on the massaging mechanism.
10 |
11 |
Loading...