Hobart ML-104822 User Manual
I
N
S
T
R
MODEL 2612 & 2712 SLICERS
MODELS
2612 SLICER
U
C
T
I
O
N
S
2612 ML-104829
2712 ML-104822
701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
FORM 34141 (12-98)
Installation, Operation, and Care of
MODEL 2612 & 2712 SLICERS
SA VE THESE INSTRUCTIONS
GENERAL
The model 2612 and 2712 slicers are equipped with a 1⁄2 HP motor and are available for single-phase
electrical service. The slicer features the exclusive Hobart Stay-Sharp contoured cast solid stainless
steel knife. The slicer is furnished with a cord and plug as standard equipment.
The 2712 slicer features automatic slicing with two adjustable speeds.
High and low carriage fences are available accessories used with front mounted meat grips. A tubular
food chute, and a 4" leg set are other available accessories.
The standard meat grip is front-mounted. Heavy front-mounted meat grip is an available accessory.
Rear heavy meat grip is also an accessory.
MODEL 2612 SLICER MODEL 2712 SLICER
© HOBART CORPORATION, 1998
– 2 –
INSTALLATION
UNPACKING
Immediately after unpacking the slicer, check for possible shipping damage. If the slicer is found to be
damaged, save the packaging material and contact the carrier within 15 days of delivery.
Prior to installing the slicer, test the electrical service to assure it agrees with the specifications on the
machine data plate. The data plate is located on the right side of the slicer base.
CARRIAGE TRAY
The Carriage Tray is secured to the slicer when the knob on the Carriage Tray / Support Arm is turned
clockwise until snug (Fig. 1). Refer to page 7 for assembly information.
SHARPENER
The Sharpener should already be mounted on top of the slicer and locked to its bracket (Fig. 1).
TOP KNIFE COVER
The Top Knife Cover should already be in place and secured with its Latch Knob (Fig. 1).
DEFLECTOR
The Deflector should already be mounted below the knife (Fig. 1).
FENCE (Low and High Fences are accessories used with front-mounted meat grip only.)
Either Fence (Fig. 1) can be clamped on the Carriage Tray to limit product movement during slicing.
Model 2612
CARRIAGE TRAY
FENCE
TOP KNIFE COVER
SHARPENER
DEFLECTOR
CARRIAGE TRAY /
SUPPORT ARM
PL-41249-1
Fig. 1
1. Back out Thumb Screw.
Lay Fence on Carriage Tray.
2. Rotate to Vertical.
3. Slide Fence Up. Tighten Screw.
ELECTRICAL
WARNING: THIS MACHINE IS PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THE
OUTLET TO WHICH THIS PLUG IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE
RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN.
CLEAN BEFORE USING
The 2612 or 2712 slicer must be thoroughly cleaned and sanitized after installation and before being
used. Refer to Cleaning, page 6.
– 3 –
Loading...