Hobart FP41 User Manual
N
S
T
R
U
C
T
I
O
N
S
I
MODEL FP41, FP61, & FP62
FOOD PROCESSORS
MODELS
FOOD PROCESSORS
FP41 ML-104345
FP61 ML-104346
FP62 ML-104347
EXECUTIVE OFFICES
701 RIDGE AVENUE
TROY, OHIO 45374-0001
FORM 18655 (8-93)
Bowl Cover
Feed Tube
Scraper
Scraper Blades
Whip Knife
Locating Pin
Handle
Splash Guard
Cut Knife
Bowl
Locating Pin
Groove for Locating
Pin of the Bowl
Indicator Knob
© HOBART CORPORATION, 1993
Arm
Drive Shaft
Groove for Locating
Pin of the Bowl
PL-40043-1
– 2 –
Installation, Operation and Care of
MODELS FP41, FP61 & FP62 FOOD PROCESSORS
SAVE THESE INSTRUCTIONS
GENERAL
The Model FP41, FP61 and FP62 Food Processors may be used for:
• Chopping and grinding meat, fish, fruits and vegetables
• Mixing sauces, aromatic butter, mayonnaise and soups
• Grinding nuts, almonds and bread crumbs
• Kneading and mixing dough
• Pureeing
Model FP41 is equipped with a 4-quart bowl. Models FP61 and FP62 are equipped with a 6-quart bowl. Models
FP41 and FP61 are single speed; Model FP62 has a high and low speed. All models have a separate pulse
function.
Standard equipment includes one cut/mix knife, a spatula, and a bowl scraper with turnable splash guard.
Optional equipment includes a whip knife, and additional bowls and knives. Also available as an option is a 4quart bowl adapter kit for Models FP61 and FP62. The adapter kit includes a 4-quart bowl, adapter ring, cut knife,
bowl cover and bowl scraper.
INSTALLATION
UNPACKING
Immediately after unpacking the food processor, check for possible shipping damage. If the food processor is
found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.
Prior to installation, verify that the electrical service agrees with the specifications on the data plate located on
the back of the machine.
Do not lift the food processor by the arm; lift only with the carrying handles located on either side.
LOCATION
Your food processor should be operated on a suitable counter height surface.
ELECTRICAL CONNECTIONS
WARNING: THE POWER SUPPLY CORD ON THIS MACHINE IS PROVIDED WITH A THREE-PRONG
GROUNDING PLUG (4-PRONG GROUNDING PLUG ON MODEL FP62). THE OUTLET TO WHICH THIS
PLUG IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE RECEPTACLE IS NOT THE PROPER
GROUNDING TYPE, CONTACT AN ELECTRICIAN.
Rated voltage of Models FP41 and FP61 is 115/60/1; rated voltage of Model FP62 is 240/60/3.
– 3 –
Loading...